This is just a partial cvt fluid change. The total fluid in the cvt trans is 8 quarts. 4 of those quarts are in the torque converter which was not changed thus mixing new fluid with old fluid. Best to use a pressurized fluid change of 10 to 12 quarts to do a proper complete fluid change.
Could you please explain the oillevel control again in detail for everyone? The filling level is said to be particularly important and many have also asked in other videos. Best regards
probly best to measure the amount of oil that you taken out, and then refill the same amount of oil to match that. at the end there is also a step to check the oil level by removing the 14mm bolt, this helps remove the excess amount of oil. If the oil running out too strong, which is an indicator of overfilling, leave it a while so the stream becomes weaker, or even stop flowing out, but anywhere between that is fine
Highly appreciated with this video, very good information, one question , in end of the video, what kind function for remove 14 mm bolt to remove oil through slowly ? Its mandatory or just option?
You have to open the 14mm .He poured in 4 qts. Full is 3.5qts. With the car running and warmed up a little you open it up and it will chug out a little and then a thin stream. It basically self levels.Then you put it back in
i have nissan xtrail 2014 petrol 2.0. i just drained oil without changing filter and added 4l ns3. should i must need to level check? i cant because i havent the tool lol. or is it ok just with 4l oil? i can remove oil from top with medical syreng. if i need minus how many ml i need to remove.? pls help.
What is temperature of transmission when you drain from overflow bolt? Why no change of filter in transmission pan? Should the fluid change not be done twice as per Nissan spec?
And there’s another filter when you drop the pan. Make sure you get the correct one. I learned there’s two different sizes, which sucks because both sizes look identical LOL Basically a size for the 18 bolt pan and a size for the 19 bolt pan lol
With out removing the oil fan you need only 4 liters,if you remove the oil fan you need 6 liters then level it while the engine is running if you have scan tool check the oil temp to 45 degree before checking the level if no scan tool warm up the engine 10 to 15 minutes then check the level...
@@kasagpi thank you for the reply. However I saw in the video that you drained the CVTF + replacing the filter but you just poured a gallon (4 liters) of the NS-3?
Thanks for taking the time to record this procedure and post it up on youtube. Much appreciated.
Glad it was helpful!
Thank you for showing how to/where to remove the paper filter. There are almost no videos that include this step.
I wish my '12 Rogue was easier to get to like this one. Mine is behind the transmission cooler.
This is just a partial cvt fluid change. The total fluid in the cvt trans is 8 quarts. 4 of those quarts are in the torque converter which was not changed thus mixing new fluid with old fluid. Best to use a pressurized fluid change of 10 to 12 quarts to do a proper complete fluid change.
2017 Nissan Rogue only has one in line filter. The one this gentlemen is showing. 2015 and under they also have a Pan filter in the transmission.
Do you recommend changing both?
Thanks for the video, I was wondering where the filter was located… how much CVT fluid in these transmissions ?
Thank you, our engineer, for the clear explanation, God bless you
Could you please explain the oillevel control again in detail for everyone? The filling level is said to be particularly important and many have also asked in other videos. Best regards
probly best to measure the amount of oil that you taken out, and then refill the same amount of oil to match that. at the end there is also a step to check the oil level by removing the 14mm bolt, this helps remove the excess amount of oil. If the oil running out too strong, which is an indicator of overfilling, leave it a while so the stream becomes weaker, or even stop flowing out, but anywhere between that is fine
Highly appreciated with this video, very good information, one question , in end of the video, what kind function for remove 14 mm bolt to remove oil through slowly ? Its mandatory or just option?
You have to open the 14mm .He poured in 4 qts. Full is 3.5qts. With the car running and warmed up a little you open it up and it will chug out a little and then a thin stream. It basically self levels.Then you put it back in
@yusufarief30 To check the fluid level
@@Thisishard2333 thx ;)
Thank you Sir! Very informative video.
thanks for the video, do you happen to have same for the 2022 Rogue?
Ayus bossing may natutunang bago Nissan extrail keep safe po.
On the paper filter was it hard to get the top bolt back in ? Would a swivel and socket work on it ?
How do you know the correct level ?
What was that last step for?? Was it checking for air pockets, like a bleeding process??
Checking for the oil level...
i have nissan xtrail 2014 petrol 2.0. i just drained oil without changing filter and added 4l ns3. should i must need to level check? i cant because i havent the tool lol. or is it ok just with 4l oil? i can remove oil from top with medical syreng. if i need minus how many ml i need to remove.? pls help.
Boss salamat sa pag shearing ng video may bago nanaman ako dagdag kaalaman
Salamat sir...
What is temperature of transmission when you drain from overflow bolt? Why no change of filter in transmission pan? Should the fluid change not be done twice as per Nissan spec?
45 degree
Último paso...se hace con el auto encendido?
What size wrench are you using to remove filler
Hey, it's a cvt jf018e ?? Message from France, thanks you
Hi, how often should I change this filter 3:27 ? Thanks.
Could you share part numbers?
Second question, how often should the filter in the oil pan be changed? Thanks again.
You can change it at 80k km.
How many quart is that fluid bottle??
Do the 2012 2.5L x-trail CVT have a filter/filter's??
Yes they’ve got that paper filter in the video but they also have another filter behind the pan so it needs to be dropped to change both filters.
Nissan technical process God job
Thanks for watching...
Sir ano Po recommended type ng ATF for Nissan X Trail 2004?
Boss same ba din yan ng nissan xtrail 2014??
Hello... great video!!! excuse me, but i hace a murano 2007 (Z50) - CVT NS-2, this car have the filter ??
There is a filter outside,on the left side of the transmission...
@@kasagpi I had to add a filter, that murano dont have .... transmission RE4FD4B FT40 in VQ35DE
Nissan murano z50 takes nissan matic J NOT NS2
Good job 👍🏼. How long should i need to change cvt oil.
You can change it every 40,000 km run..thanks...
Thanks for the video.
Boss sa T31 same
lang din ba dyan except NS2 ang fluid?
The transmission pan should have been removed and cleaned, along with the internal magnets.
And there’s another filter when you drop the pan. Make sure you get the correct one. I learned there’s two different sizes, which sucks because both sizes look identical LOL
Basically a size for the 18 bolt pan and a size for the 19 bolt pan lol
@jaredbryant8297 how to know exactly what metal filter is in my nissan rogue 2016 2.5awd
Your best bet is to call up the dealer in parts department act like your buying it ul get more attention
This car, which model
Was the car engine running when you checked the level?
Yes sir....
does NS-3 oil replace the NS-2?
Yes, on the newer models.
@@nickolastiguan ok, but we can use ns-3in ns2 vehicles
@@macofallico my guess would be no? But you have to check the owner’s manual, and/or dealer/manufacturer.
How many liter needed after CVT fluid change + filter change?
With out removing the oil fan you need only 4 liters,if you remove the oil fan you need 6 liters then level it while the engine is running if you have scan tool check the oil temp to 45 degree before checking the level if no scan tool warm up the engine 10 to 15 minutes then check the level...
hi... so that mean you need 6 liters of cvt fluid if you open up and change all the cvt filters?
@@kasagpi thank you for the reply. However I saw in the video that you drained the CVTF + replacing the filter but you just poured a gallon (4 liters) of the NS-3?
Hi. Does the 2010 Nissan Rogue have this filter?
Only strainer sir,need remove oil fan...
Yes
UMMMM what about the Pan and magnets etc???? this is not a proper service
Saan po makakabili ng legit na CVT oil at oil strainer with O-ring? Thank you!
Sa dealer po sir...
Good job mate
Thanks
Done watching bro
What year is this car?
2017 model sir..
Very interesting nice 👍
❤❤❤❤
Nice Bidio
Não trocas-te o filtro e vedante do carter, revisão mal feita