That’s how ya do it. The rear adjustments can help to raise the deck when in the up/transport position. These decks ride very low. I usually use only commercial machines. But these small residential do well. I always adjust the rear levelers to max up position and level so I can get more high lift - transport height.
Yes you fixed the inconsistent height issue but you didn't show how to raise the deck to match the setting you put it on. If I was watching correctly, you placed the lever on 4 inches but you measured the deck at the end and it was 2 inches.
That’s how ya do it. The rear adjustments can help to raise the deck when in the up/transport position. These decks ride very low. I usually use only commercial machines. But these small residential do well. I always adjust the rear levelers to max up position and level so I can get more high lift - transport height.
Good tip!
The back adjustment is actually only on one side and is to level the deck left to right..
Yes you fixed the inconsistent height issue but you didn't show how to raise the deck to match the setting you put it on. If I was watching correctly, you placed the lever on 4 inches but you measured the deck at the end and it was 2 inches.
Good catch. I believe the blade height is 4 inches of the ground. Now that I have a zero turn the levels are not the same as this machine.
What if deck leans slightly to the left about 2 inches lower than the right. How to you adjust?
check at 1:40 of the video to adjust the rear.
appreciate the good job👍🇩🇰
Thank you.
Add spacer to (front),,I cut and re- welded mine
yes, also an option, but my wheels were tired also and a replacement wasn't expensive.
Husky only cut max 4inchs he's saying high setting is 6inch ...not right
yup, you are correct, should be 4 inches.
This is misinformation. 😮
Can you elaborate?
@@Andrewsnotes1 MY understanding is that adjustment by the back wheel is for leveling. Height is adjusted by the one between the front wheels. 😉
Omg you take terrible care of your lawnmower and get to the point already
4 minute video too long for you? I service my machine yearly for the past 13 years. . What would you do differently?
That was rude. How did you even come to that conclusion? If you can find fixes less than 4 minutes it may not be fixed right. Have a little patience.
Sounds a bit judgmental to me. Now it’s your turn to add a video showing how perfect you are. 😂😂😂
How omniscient you are!