ฝัง
- เผยแพร่เมื่อ 23 ส.ค. 2024
- In this episode we pick up the welder and start buzzing together a little seat bracket to throw in some Sparco seats into the drift car!
I ended up making these seat brackets 2 times and they cost about $15 in materials to make each. The 1st was bad because the welder was set to the wrong polarity and dumb me didn't realize it. I also modified the second bracket slightly by cutting the two metal bars that connected to the sliders and cutting off the excess material in between to lose some weight.
Having a seat that will hold you in while you're drifting around the pavement is key in order to help you maintain control of your driving so you're not just holding onto the wheel for dear life. It'll also save you from bruising your elbows and legs when you are getting tossed around in the car.
Music :
VentureX - Soul
/ soul
j^p^n - springtime
/ springtime
Sorry! Please ignore the blue message at 4:14; idk how I didn't notice that before uploading 😅
derkm someone fuck the motion track
This is a great build log, this channel deserves more views
I love the vibe during the whole vid man, it was dope👌🏼
Good job. Did a similar thing to fit s2000 seats in my z4 and it was quite the pain in the neck.
Llllloved the soundtrack. Damn near put me to sleep lmao
Hahah I partially intend these videos to be a chill, sit-back-relax type vibe so glad to hear this! I think 😅
@@derkm haha forsure. Checkout my channel bro. Im swapping a small block chevy into my 87 325!
@@kelzgarage8108 subbed! ⚡️
@@derkm thanks man right back at you!
U deserve more subs bruh been watching all your vlogs , dope content bro
Thank you bro!! Really appreciate it and imma release some more for you to watch asap 🙏
@@derkm been waiting my nigga , keep em coming
love these videos man keep it up excited to see more
Killin it !
Dope camera work. You need to crank the heat up on that welder though.
Thank you man! And you're definitely right 😅 I think this was one of my first times with a welder
Very inspiring!
You welded the bracket with the chair attached? Bruh
I had a question. When you made your brackets and bolted everything on, did you sit higher compared to the original seats? Or did the height feel about the same?
I sit a little lower than the original seats. There are way better ways to make it and I'm probably going to go a different route later down the line 🤙
Can I have the measurements please
Hey I'm planning on doing this to my E36! What size square/rectangular tube did you use?
I believe it was 1in x 1.5in. That's dope though man; good luck with your project! 🤘
@@derkm Thanks for your response mate!
Where did you buy the materials
From a local metal supply shop! They're pretty generic materials so you should be able to find a local metal supply shop nearby with them 👍
Hey which model are that sparco
I got the seats second hand and dont remember the name unfortunately. They're no longer produced but I would recommend getting a seat with side mounts so you can get side mount brackets and adjust the tilt and setup on the seat better 😁
@@derkm thanx