Tips and Tricks For Using Silhouette Cameo 4 Roll Feeder and Crosscutter - Creative Design & Supply

The built-in roll feeder in the Silhouette Cameo 4 makes cutting right from the roll easier than ever!
With the Silhouette Cameo® 4, you can feed your rolled materials like vinyl and heat transfer through the back of the machine. And then cut the material using the built-in crosscutter to make a sharp, clean line.

[@xCARPx2014]

4:58 what?? I never knew you could do a test cut anywhere, I always did it in the corner. I had never even seen those arrows.

[@spicinsweet7053]

Thanks. This is just what I needed to keep my htv from rolling back. You are a lifesaver .

[@creativedesignsupply]

Thank You so much !

[@allenadayswork2216]

I learned a lot of little tricks from this video that I didn't know before! Thanks :)

[@creativedesignsupply]

Glad to hear it!

[@nahnisjourney1406]

Thank you so much for doing this video. I’ll be using these tips while using my Cameo 4 that I just got today.
Again thank you.
Happy Mother’s Day 2023!

[@creativedesignsupply]

AWWW, You're Welcome ! Happy Mother's Day to You !

[@nahnisjourney1406]

@@creativedesignsupply.
I’m finally cutting this tablecloth design after five months. I could never get it to stop shifting, however, it seems to be cutting straight once it has fed about a foot of vinyl.
I moved the stabilizer to the center instead of leaving it to the 12 inch position.
I didn’t think the noise would bother me, but OH MY GOODNESS!!! You should see the faces this noise is causing me to make. 🤪😜🤨😛😝🤣

[@janinenielson9635]

Thank you! Very helpful!

[@creativedesignsupply]

You're welcome

[@kathyfarley4922]

Thank you?! I was ha
Ving a heck of a time with my rolld of htv buckling back.

[@DIYglenn]

Is there any way to reduce travel speed?
I find that when doing large 1-2 meter text cuts, it will cut alright, but it rolls so blazingly fast back and forth, so the vinyl always ends up crooked, and the whole cut is ruined.

[@creativedesignsupply]

Yes, you can slow the speed down it is under the force button . You will need to to press the send button and then you will see it under force.

[@nicholashardiman5574]

I’m curious, how can I keep this printing continuously if I need to per se make 150 logos of the same thing? Can I use this to like press print and walk away for an hour or two?

[@creativedesignsupply]

It doesn't print it only cuts and you can set it to do 10 feet of cutting without a mat and walk away. just make sure nothing is in the way and everything should be fine.

[@nicholashardiman5574]

@@creativedesignsupply is there a setting in the software? I’m struggling to find where I can set it

[@creativedesignsupply]

@@nicholashardiman5574 You have to choose no mat and change the length to what ever size you need. no more than 10 ft

[@nahnisjourney1406]

I still can’t get the HTV to stop shifting. I’ve tried everything for so long. HELP!