The reaction time of the functions is awesome. It just takes about 4 (FOUR!!!!) seconds until something happens after pressing a button. That is high tech right there. 😀
guys im on the first calibration of the first set of calibrations, the small gear at the back doesn't turn, but the stick things at the front do PLEASE HELP SHOULD I IGNORE IT?
Hello I just finished building this I get half way thru calibrating but the. It stops the cog wheels are still going round on the app but it does not seem to finish why would this be
Possibly a failed ECU. My kit has the same calibration issue. Double checked the wiring and according to the app its all correct. The apps diagnostic software will show an error if wired incorrectly. The calibration program should begin with the blade up and down and tilt. In my case it began with the ripper! I must have run the calibration 20 times and only once did it start calibration with the blade. Am tempted to buy another Ecu just to satisfy my curiously. 😊
Ok. After much head scratching i found i had fitted the orange clutch onto the shaft back to front! Page no 108 fig 3 in book 1. Once fitted correctly and reasembled the app calibration software now runs and completes set up. It's a lengthy teardown as the transmission needs to be removed from the chassis to access that pesky clutch. Hope this helps.
Always great to see a new upload on this channel
The reaction time of the functions is awesome. It just takes about 4 (FOUR!!!!) seconds until something happens after pressing a button. That is high tech right there. 😀
does it work through wifi or just direct from the dozer?
bluetooth
@@AllTheBricksTogether thank you
guys im on the first calibration of the first set of calibrations, the small gear at the back doesn't turn, but the stick things at the front do PLEASE HELP SHOULD I IGNORE IT?
Same bro
@@clarechin2599 idk how i fixed it but i think its something with the cords.
Hello I just finished building this I get half way thru calibrating but the. It stops the cog wheels are still going round on the app but it does not seem to finish why would this be
any bigger parts left?
Possibly a failed ECU. My kit has the same calibration issue. Double checked the wiring and according to the app its all correct. The apps diagnostic software will show an error if wired incorrectly. The calibration program should begin with the blade up and down and tilt. In my case it began with the ripper! I must have run the calibration 20 times and only once did it start calibration with the blade. Am tempted to buy another Ecu just to satisfy my curiously. 😊
Ok. After much head scratching i found i had fitted the orange clutch onto the shaft back to front! Page no 108 fig 3 in book 1. Once fitted correctly and reasembled the app calibration software now runs and completes set up. It's a lengthy teardown as the transmission needs to be removed from the chassis to access that pesky clutch. Hope this helps.
Same here.. calibration stops mid trough.. did you get it to work?
My calibration freeze also
Excellent but unrealistic on the functions and overpriced 👍👍
Lento lento
Calibration freezes for me.. fucking sucks
Try a different device. I was running it on my phone and did not get past step 1. Changed to an ipad and it completed on the first try.