ET 500 receiver reset

[@Deanowp]

Nice informative vids can you please tell why does my et 500 motor gate do this when it opens it opens normal speed once its almost fully open it slows down and its very slow and vice versa

[@nicksandtrickssa]

It does crawl at the end of opening and closing. I'm glad you like the videos, please share and sub to the Chanel it helps others find the videos as well

[@taalibulilm7805]

Hi, I tried this with my board. But it didn't start flashing when I bridged those pins. It remained solid

[@nicksandtrickssa]

Thank you for the comment, try using a piece of copper wire to bridge the pins, then watch the Rx lite.

[@qudizzle1]

1) Remove power
2) Bridge all 3 pins
3) Return power (maintain 3 pins bridge)
4) Once light goes solid, remove power
5) Remove bridge, Return power

[@nicksandtrickssa]

That is it yes

[@h.product5153]

Good morning, my Et500 has a non stop beep, what do you think the problem is. TIA

[@nicksandtrickssa]

Thank you for the comment, when you say nonstop, what exactly does it do? And please describe the non stop beeping

[@h.product5153]

@@nicksandtrickssa The gate is not working at all, and the motor has a continuous beeeeeeeeeeeeeeeeeeeeeeeeeeeep
Not beep, beep, beep.......
Lol, hope you understand

[@nicksandtrickssa]

@@h.product5153 you mean a continuous tone, not beep, the beep codes work per second, not continuous... Power it down and up again. If it continues then have a technician take it to a repair centre

[@h.product5153]

@@nicksandtrickssa thanks for the information, I'm in Parow Cape Town, are you a technician, if so, where about are you. Thank you again, much appreciated

[@TheLadiesmanG]

Hi, my ET 500 just stopped working, I checked all the fuses, replaced the battery, it does not beep at all, I can see the the LED lights are on and when I press my remote I can see the LED flickering, do you know what the issue could be?

[@nicksandtrickssa]

Thank you for the comment, on a ET 500 with no beeping is difficult as the board uses beep codes to communicate, take a jumper and put it in place of the green wire (door release) and see if the board beeps

[@TheLadiesmanG]

@@nicksandtrickssa you are a life saver, thanks man, I placed the jumper on it beeps and the gate is working again, does this mean my door release is faulty? I left the jumper on in the mean time

[@nicksandtrickssa]

@@TheLadiesmanG what you can do is bend the pins, maybe the connector not making good contact, having the jumper there is a problem if you ever work on the gate as it will be on all the time even with the door open

[@TheLadiesmanG]

@@nicksandtrickssa okay I will do that, thanks again

[@nicksandtrickssa]

@@TheLadiesmanG a like and sub would be appreciated