1978 Goldwing will it run part 2... fuel tank.
ฝัง
- เผยแพร่เมื่อ 7 ก.ย. 2024
- this is part 2 of the 1978 Goldwing rescue. has been more than I thought. in this video I show how to clean the tank, removal, electrolysis, etc... #gl1000 #goldwing #honda #electrolysis #rescuemotorcycle
#gastank
![🎤 จับฉลากร้องเพลง x P’ #XXSIVK [EP.1] (2/2) เพื่อนจับได้คำไหน..ต้องร้องคำนั้น เริ่ม! 💓🎶 #MXFRUIT](http://i.ytimg.com/vi/1bJvMJXmeS4/mqdefault.jpg)
Nice wan, keep it up. 💪🛵
thank you, did the carbs and now doing the timing belts. thanks for watching
@@FranciscoGalicia The quality of the components is great and a joy to work on. With the carbs, did you use a full carb kit and balance the floats? I'm going into the carbs again on my 76 GL Ltd after I rebuilt. They are flooding the plenum and I believe it's the float levels need checking. 🤦♂
I am using good quality components. The carbs I used a new kit but some jets were so stuck there that I left them there and cleaned them pretty good so they have fluids and air flowing correctly. It was difficult to remove the carbs. Too many thing to remove.
first job old bike have take off all carburators and clean all jets and make new seals, important job, old gas closed all small holes in carb.
Totally agree. I cleaned the carbs but I haven't post the video. It was a pain. Lot of sludge that had to remove. Changed all the jets and cleaned inside. Thanks for watching
pro tip- dont use cardboard to mix up epoxy's. it soaks up the bonding compound, basically weaking the mix
Oh. Thank you so much for the tip. I really appreciate it.
Full choke to start ....leave the Twistgrip at idle position.
Agree. After all the cleaning of carbs I saw why it didn't run. Was a lot of sludge.
I have Goldwings too… I just don’t like to work on them anymore.
I think so as well. It is too complicated for the year. Other models like CB, KZ etc were simpler to work on them. Thanks for your comment
As You know one motorcycle get torn down for repairs and literally all of their parts has really taken up a lot of space in the shop… We Just got to work smarter with unforeseen circumstances. This is why I like some motorcycles that don’t break down so much.
@@Goldwing1 yes. My garage is full of components. I am going to do some cleaning this week.
simple job, take gas tank out and elektrolyse all rust off and clean tank first.
Yes. I was trying not to remove it. Ended doing it. But the was cheaper to buy another. The gas pipes were obstructed. Thanks for watching
new tank need too elektrolyse clean inside. i has before clean some tank fill inside clean nuts and gravel, then bolt tank to cement mixer and runnin mixer tank spin at mixer and sand and nuts clean all big rust, then clean tank and elektrolyse fine rust off, and last rust-off chemical come very clean tank, i has make this my honda CB550 four tank and old CB 750 four tak and some scooter tank. some little hole i has welding closed, one tractor tank i has give water cooler repair men him silver solder tank holes closed.
I thought about that but it has a mesh to pre filter the gas. So putting nuts may damage it. I did electrolisys to it.
this is repair old bike have funny perfect hobby work in garage time go funny and have good work repair old bikes back to road, go lot time but have funny and happy when all have perfect new condition, good ,i enjoy repair and build old bikes and cars and many, i has build 2 old lincoln continental mark4 and mark 5 perfect new condition, one old -76 cadillac eldorado, some toyota camry and one old jaguar new condition, funny work, retiree in Thailand now and have buy many motorbike engine need someday start repair all new condition. build chopper and daily drive bike and one motorbike engine reserve 3-wheel can-am style car. but this is future, ow i build some RC airplane my second hobby. have retiree lot time make many woodwork, all my house furnitures has made, metal work repair many local peoples tractor, repair some motorbike, etc learn make leather work, and has build cnc machine woodwork.
Wow. That is great. I also enjoy working on old things. I am fixing this one and getting it ready to sell. Then buy another project. This bike is complicated for the year. I went to Thailand in 2010. Had great time. Also noticed that cars there doesn't have like a heater, Only AC. Always hot there. Thanks for your comment