Hello, nice video! I have questions about the slide extension: Do I have to carry out the calibration every time the extension is installed and I use the F1 without it? and my 2nd question! If there are, for example, 4 coasters in the xcs, do I have to align them exactly and then measure exactly this distance on the extension and then align them? Sorry, I'm a beginner with the F1. best regards from Dortmund/Germany
Be carefull, you have the wrong protective googles. Just giving you an headsup, because ir laser on the f1 is giving out 1064nm and your googles can only take between 180nm-540nm.
If you are adventurous and prepared to take the time to measure, tape off, do things in stages, then the only size limitations are your imagination and resolve. Where there is a will..
![จากรุ่นใหญ่สุดรวยในเกม FIVEM สู่การติดคุกแก๊งแตกในชีวิตจริง [สรุปแก๊งOREO]](http://i.ytimg.com/vi/Vjj8EX4qpiU/mqdefault.jpg)
![บังเอิญมันได้อ่ะ - แอน อรดี [OFFICIAL MV]](http://i.ytimg.com/vi/9fwjammKY4A/mqdefault.jpg)
Wow, thanks! This is the best and most thorough review I've seen of the xTool F1. 😎🔥🙌
Thanks! Glad it was helpful for you!
Week done video. Very informative.
Well done review!
Hello, nice video! I have questions about the slide extension: Do I have to carry out the calibration every time the extension is installed and I use the F1 without it?
and my 2nd question! If there are, for example, 4 coasters in the xcs, do I have to align them exactly and then measure exactly this distance on the extension and then align them? Sorry, I'm a beginner with the F1.
best regards from Dortmund/Germany
How does it know where to put the design without a camera? Do you set up a perimeter size for it to go by for the design?
When using the slide, you don’t put the cover down to protect your eyes from the laser?
real time engraving or are the speed up?
I have tried to tighten the two screws down and nothing happens. Any ideas or help would be greatly appreciated.
what is the setting for the cork coaster you did,
Be carefull, you have the wrong protective googles. Just giving you an headsup, because ir laser on the f1 is giving out 1064nm and your googles can only take between 180nm-540nm.
No one can tell me the measurements of the biggest thing they engrave in the X Tool F1 engraver and cutter
I think in another video i saw that it was 4 in x 4 in
If you are adventurous and prepared to take the time to measure, tape off, do things in stages, then the only size limitations are your imagination and resolve. Where there is a will..
The extension table is a bonus. Like with anything though, the work you are prepared to put in will increase the capacity.