Issue was the ecm had water underneath the connector brown liquid causing the car to go crazy cause anit theft to go crazy gauges went hay wire. When connector was removed it broke cause a problem with the ignition system where it wouldn't crank the stall after cleaning and drying out the ecm plus had to replace whole engine harness car now runs awesome haven't had any issues since. Before all this happen was stalling a lot out of the blue possible thought crank shaft sensor was dying it wasnt even tho it was replace with a new one. Now please be aware if you are planning on washing or degreasing your engine with a pressure washer or water hose that can also get water into your ECM due to a bad design on the cover that covers the ECM cuz it's only a top cover doesn't protect the bottom. So if you have no leaks that's another possible thought
ok thanks for the reply, I have the stalling out of no where issue and can't figure out what it is. I checked the ecm and did not see any liquid or water but will check the harness to see if the clips are broken, thanks again for the info @@WorldWideMediaGroup1
@@PanterasWickedness it can also be your crankshaft position sensor cuz I know that if they start to fail that can also cost stalling too. In my crankshaw position, sensor went bad without an engine light and after I replaced it with a good aftermarket brand, it ran fine as well and those cars are well known to stall with a bad crankshaft position sensor
Hi did this fix the stalling issue out of no where you had?
Issue was the ecm had water underneath the connector brown liquid causing the car to go crazy cause anit theft to go crazy gauges went hay wire. When connector was removed it broke cause a problem with the ignition system where it wouldn't crank the stall after cleaning and drying out the ecm plus had to replace whole engine harness car now runs awesome haven't had any issues since. Before all this happen was stalling a lot out of the blue possible thought crank shaft sensor was dying it wasnt even tho it was replace with a new one.
Now please be aware if you are planning on washing or degreasing your engine with a pressure washer or water hose that can also get water into your ECM due to a bad design on the cover that covers the ECM cuz it's only a top cover doesn't protect the bottom. So if you have no leaks that's another possible thought
ok thanks for the reply, I have the stalling out of no where issue and can't figure out what it is. I checked the ecm and did not see any liquid or water but will check the harness to see if the clips are broken, thanks again for the info @@WorldWideMediaGroup1
@@PanterasWickedness it can also be your crankshaft position sensor cuz I know that if they start to fail that can also cost stalling too. In my crankshaw position, sensor went bad without an engine light and after I replaced it with a good aftermarket brand, it ran fine as well and those cars are well known to stall with a bad crankshaft position sensor
ok cool and many thanks will check it out and see if that is also my issue @@WorldWideMediaGroup1