thank you thank you thank you thank you!!! I've been trying to loft a square to a circle using two spiral guide curves (because one wouldn't work) and it wouldn't let me pierce the point with the guide!!! This video is great... you just saved me hours of research.
If any one is confused on where to start, draw a circle on the top plane matching the outer diameter of your coil, use the Helix/Spiral feature to make your path, I used Height and Revolution for dimensional output. Then draw your rectangular pattern with the outer edge coincident with the start of the spiral. The inner edge will set the I.D. Then use sweep feature, the rectangle sketch being your profile and the spiral being your path. I did this to draw a simple lock washer.
Hi, I was looking for some guidence to make a spiral slide with a 'U ' shaped / semi circle bucket of 800 mm width with 1-1/2 turn. I also want to know if i can make proper sheet metal drawings for the spiral slide? Pl help.
G'day, I trying desperately to generate a simmilar model ie tapered metal helix joint with a tube. Can u pls help. Dont mind paying u. pls contact ASAP. Thanks Haman
thank you thank you thank you thank you!!! I've been trying to loft a square to a circle using two spiral guide curves (because one wouldn't work) and it wouldn't let me pierce the point with the guide!!! This video is great... you just saved me hours of research.
If any one is confused on where to start, draw a circle on the top plane matching the outer diameter of your coil, use the Helix/Spiral feature to make your path, I used Height and Revolution for dimensional output. Then draw your rectangular pattern with the outer edge coincident with the start of the spiral. The inner edge will set the I.D. Then use sweep feature, the rectangle sketch being your profile and the spiral being your path. I did this to draw a simple lock washer.
Great video - thank you! This was very helpful!
Hi,
I was looking for some guidence to make a spiral slide with a 'U ' shaped / semi circle bucket of 800 mm width with 1-1/2 turn. I also want to know if i can make proper sheet metal drawings for the spiral slide?
Pl help.
How about a lofted/multi-radius boat hull? Is this possible?
thanks man you are the best
could you make a Felco spring ?
Thank you!
G'day,
I trying desperately to generate a simmilar model ie tapered metal helix joint with a tube. Can u pls help. Dont mind paying u. pls contact ASAP. Thanks Haman