P28 Honda obd1 ecu auto to manual conversion and removal, p06 p05 as well, getting ready for Hondata

Convert your Honda Acura obd1 ecu from an automatic ecu to a manual ecu. Will work with Hondata s300. Will work on p05 p06 p75 p28 auto to manual. I’m not sure about the Jdm automatic p72 and other JDM automatic computers.
Yes this was an ugly soldering job 🤣 I don’t think my anesthesia had worn off from the day before.

[@kodyvandevoort]

What code would trip if you dont change it

[@i4boosting328]

Auto solenoid since no signal going to ecu

[@DA9Darius]

Will this work on pr4 automatic ecu? To 5 speed manual?

[@i4boosting328]

It should, it does on the p75 which is newer version of the pr4. Just look to see if they are the same and double check a schematic online so you’ll know because I’ve not done one before

[@3dTinker]

What else can i use to bridge the rp17

[@i4boosting328]

Just about any type wire that you can solder in that won’t touch anything else

[@UnknownLantan]

Will this work on my 04 civic?

[@i4boosting328]

I’ve never opened one up on a 01-05 civic I’ve ran automatic computers that has had a 5 speed swap but it just had the check engine light on for it. I’ve k swapped a 2001 ex as well but we ran kpro

[@UnknownLantan]

@@i4boosting328 oh ok. Thanks a lot bro

[@hansaguilera5760]

So otherwise to convert manual to auto? Can i use p06 manual to p28 auto?

[@i4boosting328]

You can make a p06 ecu into a p28 ecu and it doesn’t matter if it is automatic or a manual but if your wanting to make a manual into automatic I’ve never tried that b4