How to make a battery level indicator using Breadboard | Breadboard projects | Creativity

In this tutorial video you will learn how to make a Breadboard circuit that indicates battery level
Things used in this video-
● Breadboard
● Jumper wires
● 1k ohm resistors
● LED Bulb (5)
Don't forget to subscribe Creativity channel for more creative videos!!!
Watch more videos of creativity-
4 Amazing dc motor hacks-
• 4 Awesome Projects fro...
3 Creative ideas to reuse old plastic bottles-
• 3 Genius Life Hacks fo...
How to make Thor's eye patch from THOR RAGNAROK-
• How to make Thor's eye...
How to make Black panther's claws from paper-
• How to make Black pant...
How to make A DIY table fan using Plastic Bottles-
• How to make a DIY tabl...
How to make a DIY Water Level Indicator Alarm without using Transistors-
• How to make a DIY Wate...
How to make DIY Air Blower-
• How to make a Homemade...
How to make a DIY battery connector-
• How to make a DIY 9 vo...
How to make a DIY Toy car-
• How To Make A DIY Toy ...
How to make a Touch sensor circuit on a breadboard-
• How to make a touch se...
breadboard connection
breadboard projects
breadboard tutorial
breadboard basics
breadboard series and parallel connection
breadboard connection in tamil
breadboard computer
breadboard explained
breadboard circuit
breadboard connection in hindi
breadboard projects for beginners
breadboard projects for engineering
breadboard projects in tamil
breadboard projects without arduino
breadboard projects easy
breadboard projects simple
breadboard projects with arduino
breadboard projects malayalam
breadboard projects in hindi

[@vinitasingh6255]

Nice Video👍👍

[@bhawnasingh4935]

Very useful 😊

[@bhawnasingh4935]

Good job👍

[@umxamv532]

youtube mai video kaise upload kartea hai ek video banao uske upar mere liya nice video but the led bulb where you buy at this time

[@Creativity06]

LED bulb pehle se hi tha mere paas

[@jyotiacharya3902]

Use variable power supply 0-30 DCV ... instead of changing batteries, it would help you alot 🤗

[@ganeshaguru2187]

How can I supply variable power supply. Please tell me

[@jyotiacharya3902]

@@ganeshaguru2187 hi, use regulated power supply 0-30 DCV....just connect input terminal of ckt with supply ports...with correct polarity..then rotate the selector switch of supply and vary voltage 0-30Dcv as required simple👍

[@barathraj7736]

nice

[@smartboyanjiyadav2198]

Bro what about circuit diagram please upload it are share me link

[@zappa4153]

It didn't work for me, had a couple of projects that hasn't worked for me and I've set them up the same way.

[@bhawnasingh4935]

Need to re work ur approach

[@thetooginator153]

When I was just starting, it was hard for me to figure out the polarity on some projects.
On this project, the grey wire goes to negative on the battery and the white wire goes to positive. Make sure you put the LEDs in the proper polarity too. The first LED pin is negative, then the positive pin goes to the negative pin on the next LED. The resistors all go to negative.
Watch the polarity of each component and it should work. Make sure your LEDs work too. LED testers are pretty cheap, and I use mine all the time.

[@shiyanahendry5150]

It didn't work for me