Symmetry model in ABAQUS

[@scottmcelfresh4776]

Great explanation

[@ethanmorgan8839]

what would the BC be in the centre if there wasnt a hole

[@jha825]

hi sir thanks for sharing it can you clarify normalised quantity ..........can you give some more example where we have to use the same value for both full model and quarter model

[@jha825]

if we model the same problem in 3D than how will we define boundary condition

[@haniffathi3199]

why is it 206e3?

[@adarshshah4309]

Dear Sir, Can we do the same for three model also?

[@10Minuters]

Yes, you can do the same for 3D models.

[@adarshshah4309]

@@10Minuters Thank you Sir!

[@pratikgoel2996]

Will the axial load also quartered on quartering model??

[@10Minuters]

Hi, As the cross-section is reduced by half in this example, load is also half

[@pratikgoel2996]

@@10Minuters not in this problem suppose we consider a symmetric column with 10kn load but we model only one fourth column will load taken be 2.5 kn

[@10Minuters]

Yes, in that case load will be 2.5 kN

[@narendrakumarjha5685]

@@10Minuters and from the final outcome shall we multiply by 4 to get the result for full model

[@10Minuters]

@@narendrakumarjha5685 Just multiply by 2

[@narendrakumarjharesearchsc5159]

after doing mirroring one part go over the other problem

[@10Minuters]

Check that your mirror line is along x or y axis line while sketching the 2D geometry

[@narendrakumarjharesearchsc5159]

@@10Minuters y axis same as yours

[@narendrakumarjharesearchsc5159]

can you check my model