Plastic-Welding-PP-Enclosure.mp4
ฝัง
- เผยแพร่เมื่อ 12 ก.ย. 2024
- Plastic Welding of Polypropylene enclosure - In this video a small PP electronic enclosure is being welded to a backing plate (also PP), using the Techspan Rion plastic welding tool. A red welding rod is used simply so you can see the welding rod clearly. Firstly, a tacking nozzle is used to 'Tack' the enclosure to the backing sheet. Then a Speed Welding Nozzle is used to run the main welding rod. The results provide a low cost way of providing a 'water tight' weld.
For further information visit us at
www.techspanonl...
An awesome piece of equipment, and so easy to use, just love my techspan rion
Hi, have you ever tried to make tanks or enclosures from polypropylene sheets? We want to build tanks with inside divisions from these sheets for wastewater treatment and we'd appreciate your insight on the matter!
Yes this is possible. We know of one customer who fabricates tanks from flat sheet. He uses a 'line heater' and folds up the sides, then welds the joins with an 'Extruder Welder' (used for welding large wall section materials 10mm and above)..
For more information, feel free to email me here >>
info@techspangroup.com
thank you
it looks like the first tack weld you did looked really smooth and consistent. any advice on the tip type, type of welder or temperature? Also what was the strength of just the first tack weld you did?
Hi David Frank, thanks for your comment - Tacking is to acheive two objectives. To assist in aligning the work and also to close up the joint interface. But tacking does not provide structural strength. It is only when the welding rod is added that strength is achieved. Usually to between 95 - 100 % of the parent. As far as the tacking nozzle is concerned, you can view all our accessory nozzles here >> www.plasticweldingtools.com.au/product-category/accessories/
Hope this is helpful.
@@TECHSPANONLINE hi there.. so the first stike is for prepare before we apply with rod right?
@@gustanto1981 www.plasticweldingtools.com.au/how-to-weld-plastics/
@@TECHSPANONLINE thankss
@@gustanto1981 www.plasticweldingtools.com.au/how-to-weld-plastics/
Wat is that nozzle u have at the end where u feed the rod thru??? And how strong is this weld?
Speed Welding Nozzle... see all our accessory nozzles here >> www.plasticweldingtools.com.au/product-category/accessories/
Plastic welding carried out to these guidelines will provide extreme strength >>
www.plasticweldingtools.com.au/how-to-weld-plastics/
Hello. Please tell me where I can buy some of these backing plates.
From a plastic sheet supplier :-)
Try Mulford Plastics
Ok just visited their site and I see only "PP thinwall flute" of which there are only 4 products, non of which would be suitable for my intent of extending vehicle headlight housings. Please more suggestions.
Try DOTMAR Plastics