I think it will run up to 3/8 but I haven't gotten to do much testing just yet. I'll see for sure when I start cutting some of the old exhaust hangers out from underneath
With the sheet metal covering the edges of the tires... are you going to be able to get the tire off? It looks like you have to slide the wheel out a couple of inches to clear the hub.
Great question... I have no idea to be honest. On the driver side there's much more clearance with the proper tire size on that side I think it will be able to slide out once the suspension is decompressed, but if jacked up by the axle I don't think it will be possible
The truck is looking good.
I like the plasma cutter having its own compressor that seems convent how thick will it cut.
I think it will run up to 3/8 but I haven't gotten to do much testing just yet. I'll see for sure when I start cutting some of the old exhaust hangers out from underneath
Great job on the ramp truck. How can I obtain that same plasma cutter?
It's no longer available
With the sheet metal covering the edges of the tires... are you going to be able to get the tire off? It looks like you have to slide the wheel out a couple of inches to clear the hub.
Great question... I have no idea to be honest. On the driver side there's much more clearance with the proper tire size on that side I think it will be able to slide out once the suspension is decompressed, but if jacked up by the axle I don't think it will be possible