1997-2003 F150 Key/Ignition lock

How to disassemble and reassemble lock tumbler
Assembly/Installation
1) Insert one tumbler spring into each hole, and install appropriate gate into tumbler. Do this for all 7 gates
2) Install key to verify all gets are flush with the lock cylinder exterior surface
3) Assemble key minder (orange) switch into case. switch is very delicate, handle with care
4) Apply grease: Generous amount into case body, and around locking detent
5) Install key minder (black) plastic actuator into tumbler cylinder
6) with key in the lock cylinder, insert lock cylinder into lock housing
7) Use a small flat head screwdriver to lift the locking Dtent spring
8) Insert spring
9) Insert ball bearing
10) Insert locking Dtent
11) Rotate key clockwise to engage the ball bearing into the slot
12) Remove key and verify correct lock operation
13) Install completed lock assembly into the steering column

[@bethbabson913]

So not just a screwdriver and pop in a new switch as another video. Plus it said maybe need dealer reprogram a key. I don't think so as copies always worked.

[@Patman03sprcrw]

Will need to reprogram if you have a new chip key. But if you have 97 or 98 you don't have PATS, so it would be a standard key. The ignition lock portion in the video should still apply tho

[@alexandervargas492]

just got a 1998 that's need the switch, so the doesn't need to be programmed?

[@Patman03sprcrw]

1998 predates PATS security. No programming

[@andrewballard9805]

Where you from I need mine done

[@Patman03sprcrw]

Dallas Texas

[@jbeasty30]

Link to the gates?

[@Patman03sprcrw]

Part of the ignition rebuild kit.
1L3Z-11582-A