Really learning alot from your videos mate. Got a question though, if the one way and lock diffs are installed what gyro percentage would you recommend, thanks.
hey! it will vary depending on the gyro brand and each car., some cars with very low Left Right EPA can't handle a lot of gyro gain because the wheel will wobble a lot but I would normally start with this. Try a high setting first like 70% Move the car forward straight if the wheel is wobbling then it's likely you have too much but a little bit of wobble is ok as long as it's not too noticeable. Then when drifting, if you struggle to kick the tail out (oversteer) then it's likely you have too much gyro gain, so reduce further. But if you find that you're fish tailing too much and the drift is not very smooth then it's likely you have too little gain try increasing it. I usually work with 5% increment to notice any difference. with Radiolink gyro and 4wd setup, I normally use 25%-35% for 50:50 and with Countersteer setup I use about 40%-50% hope this helps and thanks for watching!
Interesting test. I just tested this controller with a proper RWD drift chassis. I am surprised how much trouble you were having with AWD. Is it still 50-50 driven, or are you overdriving the rear axle?
It is still 50:50, the Tamiya Driftech tires were quite difficult to use on asphalt and I wanted to use only Tamiya gear. Also in this video I was using stock diff for the demo of just adding a gyro and see what happens, will replace both diffs for next video BTW I'm a big fan of your drift videos! thanks for commenting.
Great video! I don’t have a tt02 but wondering your thoughts on general for gyros. Does placement of the gyro matter? If it does would it be better to have it on the side like the tt02 or would in the front between the wheels be ok?
I've been meaning to make a video about that. It matters a little, it shouldn't be on the servo because the servo vibrates. Ideally it should be rear center of the chassis if you can, it will make it response slightly better because you get more movement on the rear side but it's not a big deal.
What electronics are you using? I’m new to this whole thing and not sure what electronics to get, Taniya does have a kit but it doesn’t look that good.
I always run brushless, Tamiya TBLM-02S brushless motor series are good value. Otherwise I also run the cheapest Hobbywing and G-Force brushless motors and 60amp ESC. I have so many cars it's too expensive to run the good expensive motors. For the transmitter & receiver I run Radiolink RF6G series because the transmitters are cheap and has a built in Gyro which saves me a lot of money from buying gyro and its good enough for CS drifting. As for battery, I recommend you spend extra on nice Brand name 2s Lipo. I had too many cheaps ones that fail on me and had to throw away after it bloats. I like Gens Ace Redline series which is really good.
hi the gyro I was using is built in with the Radiolink Receiver so its a 2 in 1 Reciever +Gyro and its real cheap. Otherwise you would need to get seperate gyro for around $20
@@Chris-vc1dh reverse and brake is really the same thing usually this is controlled by the ESC, where from going from Throttle > Reverse Throttle is braking, but if you tap the reverse throttle for the 2nd time then it goes into reverse.
![[TH] VCT Pacific Stage 2 - Week 4 Day 3 // GEN vs TS | PRX vs ZETA](http://i.ytimg.com/vi/nspkjQuZve0/mqdefault.jpg)
Great video. Now I’m on my way to the hobby store to get a similar setup
Great vid - I've been wanting to upgrade mine to a radio with a gyro
😊😊
I'm thinking of getting one of those remotes.
never seen awd drift with gyro before, except cs system :D but this VDO is very nice experiment
it's much smoother with gyro, didn't expect you to visit my amature videos thanks a lot!
hello thank for video
Really learning alot from your videos mate. Got a question though, if the one way and lock diffs are installed what gyro percentage would you recommend, thanks.
hey! it will vary depending on the gyro brand and each car., some cars with very low Left Right EPA can't handle a lot of gyro gain because the wheel will wobble a lot but I would normally start with this. Try a high setting first like 70% Move the car forward straight if the wheel is wobbling then it's likely you have too much but a little bit of wobble is ok as long as it's not too noticeable.
Then when drifting, if you struggle to kick the tail out (oversteer) then it's likely you have too much gyro gain, so reduce further. But if you find that you're fish tailing too much and the drift is not very smooth then it's likely you have too little gain try increasing it. I usually work with 5% increment to notice any difference.
with Radiolink gyro and 4wd setup, I normally use 25%-35% for 50:50 and with Countersteer setup I use about 40%-50%
hope this helps and thanks for watching!
Interesting test. I just tested this controller with a proper RWD drift chassis. I am surprised how much trouble you were having with AWD. Is it still 50-50 driven, or are you overdriving the rear axle?
It is still 50:50, the Tamiya Driftech tires were quite difficult to use on asphalt and I wanted to use only Tamiya gear. Also in this video I was using stock diff for the demo of just adding a gyro and see what happens, will replace both diffs for next video
BTW I'm a big fan of your drift videos! thanks for commenting.
How did you like it? I'm thinking of getting one for my Sakura d5 hybrid.
@@B20V-SOL It works, but I highly suggest spending the extra $$$ and getting a better controller.
@@RoadsideRC I have a futaba T3PV.
Great video! I don’t have a tt02 but wondering your thoughts on general for gyros. Does placement of the gyro matter? If it does would it be better to have it on the side like the tt02 or would in the front between the wheels be ok?
I've been meaning to make a video about that. It matters a little, it shouldn't be on the servo because the servo vibrates. Ideally it should be rear center of the chassis if you can, it will make it response slightly better because you get more movement on the rear side but it's not a big deal.
@@monsrc3122 thank you!
Question is who is drifting with out gyro? kinda first thing u need tbh I use gyro on all my cars apart from my crawler and my drag car.
you should check my TT02 out. It's wild!
Thanks.. Btw how you record this while playing?
I use a gopro strap to my chest or head
I see, thanks.. Will try that later :)
What electronics are you using? I’m new to this whole thing and not sure what electronics to get, Taniya does have a kit but it doesn’t look that good.
I always run brushless, Tamiya TBLM-02S brushless motor series are good value. Otherwise I also run the cheapest Hobbywing and G-Force brushless motors and 60amp ESC. I have so many cars it's too expensive to run the good expensive motors.
For the transmitter & receiver I run Radiolink RF6G series because the transmitters are cheap and has a built in Gyro which saves me a lot of money from buying gyro and its good enough for CS drifting.
As for battery, I recommend you spend extra on nice Brand name 2s Lipo. I had too many cheaps ones that fail on me and had to throw away after it bloats. I like Gens Ace Redline series which is really good.
gryooooooooooooooo
Did you do a video with the locked diff and front one way with gyro?
yes check out th-cam.com/video/LglXv_KUvtY/w-d-xo.html it's super smooth now
@@monsrc3122 thank you and thank you for replying 🙏
Just saying you wrote GYRO wrong:)
does the tt-02 come with a gyro or is the gyro just a necessary add-on
hi the gyro I was using is built in with the Radiolink Receiver so its a 2 in 1 Reciever +Gyro and its real cheap. Otherwise you would need to get seperate gyro for around $20
do you know how to make reverse throttle less aggressive in this radio?
The correct way to do it is to change the "ATL" settings and reduce it from 100%
@@monsrc3122 thank you I will test it today.
Do you know please how to set brake in this radio?
@@Chris-vc1dh reverse and brake is really the same thing usually this is controlled by the ESC, where from going from Throttle > Reverse Throttle is braking, but if you tap the reverse throttle for the 2nd time then it goes into reverse.
Where can I get the one way diff at ??????
Eagle racing is best value www.broadtech.hk/eagleshop/shop/ShopProductDetail.aspx?id=TT02-18U
Is there a gyro seperate not with the reciever?
you can use separate gyro any cheap one will work fine.
@@monsrc3122 any brand recomendation? Im new to this😁
@@jannacino5495 I would go Yeah Racing for the budget option
it is still 4wd? with normal diffs right?
yes with normal diff, it's not a very good video because I was using the Tamiya drift tech tyres which are really bad for the surface.
TBH thats a terrible chassis
you get what you pay for.