DIY Audi A4/S4 (B9) Bumper Removal & Grille Installation

In this video, we should you how to remove the front bumper on the Audi A4/S4 (B9). We also show the process of removing the stock grille, for those looking to install an RS-style grille. Looking to purchase one of these grilles? Head over to our website here:
www.emmanueled...

[@snatchman69]

One thing to remember is that you’ll also have to disconnect the wiring for the ACC radar and front camera before removing the bumper, for those who have them installed. Thanks for this video! Made installation a breeze. And the EMD bracket for the front camera mount was perfect!

[@jamesbrown2163]

There is a plastic clip you have to remove on the top part of the bonnet latch on the A4-B9 model.
I used a tiny screwdriver to pull back the plastic circlip.
You can't just pull up on the knob. I was able to vacuum grass hoppers which had gone through the grill and made a mess.
I just lifted out the top plastic piece and was able to clean behind the grill.
Thanks a lot for this video. Most helpful.

[@weshoothemoon]

I almost broke it off until I read this, thanjs

[@adycrap]

Thanks for that i couldnt open mine aswell

[@Danny-he3tx]

very well explained. shown very precisely. Thanks for the video.
Greetings from Germany

[@ricric9521]

Is there a license plate attachment or bracket for this grill if needed?

[@Julian31NLD]

Thanks, you made it super easy 😁

[@kingpreetham]

Do the same/similar instructions to remove the bumper apply to the S5 Sportback? Thanks

[@ayelexi]

Where did you buy the grill? Did it fit perfectly? As in did it have a place for your wires to attach and front camera...

[@wie_luggi]

Within the B9 from 2019 is the grille the same as the 2015-2018 model and just the ACC cover has been redesigned? At least the 2020 model got a different grille. I'm a bit confused about the differences of the facelifts from 2019 and 2020 and can't find a particular description which grilles are compatible with my 2019 B9...

[@Sean-pb5cn]

I suppose these steps are going to be really similar to B9 A5? Also I would use plastic trim tools to disengage tabs to minimize scratches and surface damages, instead of screw drivers.

[@christiancortesi5136]

Do you know the PN code of the side air intakes that are fixed internally? To be clear where the third side screw is to be screwed

[@dnero51]

Great video... After you took off the bumper and detach the parking sensor wires. How did you take off the Parking sensors off the original grill and mount it on to the RS grill?

[@robertsicilia7261]

any advice here?

[@danc843]

2019 sline a4 looks same took all those screws clips out and bumper still stuck

[@jvaglivelo]

Did you ever figure this out? same issue with my 2019, bumper is stuck around the headlights it seems

[@JamieWardVideos]

@@jvaglivelo Im looking to do this on my 2019. Did either of you figure it out?

[@giggitypigeon9612]

@@JamieWardVideos just inside the side of the bumper next to the fender, there’s 2 10mm nuts facing down in a little plastic bracket, if you just loosen those up a little bit, the bumper should pull out freely, not sure why he didn’t mention that step maybe his were loose

[@markkang1587]

can you provide a link where we can purchase the RS type grill ? thanks

[@Emmanueledesign]

mark KANG Yes, it is in the description.

[@its2realj]

Is this the same grill for the B9 S5 Sportback? thanks!

[@Emmanueledesign]

its2realj No the S5 is a different grille.

[@omg_its_kenoizo9724]

Can u do it without removing te wheels?

[@juhthreef]

most likely yes by turning them to the opposite side you are currently working on.

[@majinbulsk5106]

Could it still able to connect the parking sensors on the new RS or S grille?