ขนาดวิดีโอ: 1280 X 720853 X 480640 X 360
แสดงแผงควบคุมโปรแกรมเล่น
เล่นอัตโนมัติ
เล่นใหม่
Dude’s a damn genius! Thank you!!
Glad the video helped.
I have no grease so ill be trying this right now i will come back and let you knownhow it went
Use a bolt and nut, hold the nut in place on the backside of the bearing with the screwdriver. Hope the video helped
Just remember though an LS has a plug you can push through. That’s a sweet method on most other motors.
Usually I replace the cheap pilot.just a little heat and a prybar that will catch the hole.this is smart too tho
That’s pretty slick 👊
Genius!!
Thanks! Hope it helped.
Thanks 👌
Your welcome
Woooooooow I’m going to try that
Hope it works out. I used one of the bolts from bell housing to engine and found the same thread nut
@@IdJeepThat I might have to use something different my crank hole looks under half inch it’s a old Datsun motor
fill the hole up with grease and find a steel rod/bolt that fits snugly into the ID of the bearing. Then just give the steel rod a pop with your hammer and the pilot bearing will pop out slick as boiled okra.
Haha! I’ll have to try both some okra and that method next time.
😮 wizardry techniques
Are you kidding me right now? I just dropped 70 bucks on a puller set
I didn’t have a puller small enough
Holy crap does that work?
Yes, it worked really well.
NEVER DO THIS ON LS ENGINES!!!!!!!
Dude’s a damn genius! Thank you!!
Glad the video helped.
I have no grease so ill be trying this right now i will come back and let you knownhow it went
Use a bolt and nut, hold the nut in place on the backside of the bearing with the screwdriver. Hope the video helped
Just remember though an LS has a plug you can push through. That’s a sweet method on most other motors.
Usually I replace the cheap pilot.just a little heat and a prybar that will catch the hole.this is smart too tho
That’s pretty slick 👊
Genius!!
Thanks! Hope it helped.
Thanks 👌
Your welcome
Woooooooow I’m going to try that
Hope it works out. I used one of the bolts from bell housing to engine and found the same thread nut
@@IdJeepThat I might have to use something different my crank hole looks under half inch it’s a old Datsun motor
fill the hole up with grease and find a steel rod/bolt that fits snugly into the ID of the bearing. Then just give the steel rod a pop with your hammer and the pilot bearing will pop out slick as boiled okra.
Haha! I’ll have to try both some okra and that method next time.
😮 wizardry techniques
Are you kidding me right now? I just dropped 70 bucks on a puller set
I didn’t have a puller small enough
Holy crap does that work?
Yes, it worked really well.
NEVER DO THIS ON LS ENGINES!!!!!!!