Absolutely 100% perfect instructional video. Am going to check this on my '08 Impreza hatch (442,000 km). I hope your child's art work is still on your man door - that makes the room!
Wow, thanks for the video! That little, cheap looking, thing sure caused a lot of problems on my 2016 outback 3.6R. It was good to know for sure the part was bad before ordering a new one. It took about 10 minutes to replace.
Hello can you please answer my map sensor signal is at .94 sometimes drops to .92. But i already switched my map sensor twice and hasnt fixed the issue does this mean than i have a wiring harness issue ? Please answer 🙏
hi, on my 2015 subaru outback I found my signal, power and gorund wire, but on the power wire I get a 5.01Volt reading but the singal wire I get a 4.9 volt with 0.05 fluctuation when I accelerate. Does that mean I have a faulty sesor or wire? Thanks, great video otherwise
I know it might be a little late but I would use a screw a little larger than the inside diameter of the tube that broke off. Screw it in slightly then wiggle and pull. I use this technique sometimes and it works great.
![ตีสิบเดย์ [FULL] | นางเอกหมอลำเงินล้าน "อุ๋งอิ๋ง เพชรบ้านแพง" & ไฮโซสาวสุดฮอต "ลิลลี่ เหงียน"](http://i.ytimg.com/vi/jPxQS_EgrJ4/mqdefault.jpg)
You have the single most comprehensive video from explanation of this topic. Genuinely thank you for your hard work and your dedication to your craft.
Absolutely 100% perfect instructional video. Am going to check this on my '08 Impreza hatch (442,000 km). I hope your child's art work is still on your man door - that makes the room!
Wow, thanks for the video! That little, cheap looking, thing sure caused a lot of problems on my 2016 outback 3.6R. It was good to know for sure the part was bad before ordering a new one. It took about 10 minutes to replace.
Hello can you please answer my map sensor signal is at .94 sometimes drops to .92. But i already switched my map sensor twice and hasnt fixed the issue does this mean than i have a wiring harness issue ? Please answer 🙏
Great until the end when you didn't say what those out of spec readings meant. Bad sensor or bad wiring? I'm assuming sensor?
hi, on my 2015 subaru outback I found my signal, power and gorund wire, but on the power wire I get a 5.01Volt reading but the singal wire I get a 4.9 volt with 0.05 fluctuation when I accelerate. Does that mean I have a faulty sesor or wire? Thanks, great video otherwise
keep your work
I snapped mine odd inside the throttle body removing the throttle body to clean it, UGH! any suggestions to remove it
I know it might be a little late but I would use a screw a little larger than the inside diameter of the tube that broke off. Screw it in slightly then wiggle and pull. I use this technique sometimes and it works great.
Hey, my sensor is reading 25-27 kPa average except it sometimes shoots to 30-37. I have a P0108 code. Is it fine?
I’ll go for a drive and see what happens