Hello. Which brand of flywheel and rear main seal did you use? I bought a Luk flywheel but does not fit the center hole is too small and does not slide on the crankshaft. Thank you.
Actually I bought the truck like this, got the truck cheap with no transmission and exhaust was already cut. been doing work on it. I personally would have just unbolted the exhaust. Because they cut it I had to take it off and go to a welding shop to have them weld it back and then it wasn’t lined up right and had to try in bend it a little to make it fit right
Why is it I can't get the flywheel to line up in bolt on
Hello. Which brand of flywheel and rear main seal did you use? I bought a Luk flywheel but does not fit the center hole is too small and does not slide on the crankshaft. Thank you.
Great work smart move cutting the exhaust it's so much easier to weld back than to take the whole thing off
Actually I bought the truck like this, got the truck cheap with no transmission and exhaust was already cut. been doing work on it. I personally would have just unbolted the exhaust. Because they cut it I had to take it off and go to a welding shop to have them weld it back and then it wasn’t lined up right and had to try in bend it a little to make it fit right
@@natethecalijiu side pipes, w running brds . 😉
My pilot needle bearing
was in flywheel, 94 4.0 L
2wd.
What torque specs did you use for the flywheel and pressure plate? I’m in the middle of replacing mine atm
50 ft-pounds for the flywheel, and 24 ft-pounds for the pressure plate
@@natethecalijiu you are a lifesaver!
not a sound out of your mouth when you was doing it lol