CX500 carbs slow, pilot, idle jet removal, overhaul and replacement/

The age old problem of the idle jets in the Honda CX500 (pressed in ) jet.
This video shows how to remove it, clean it, and then to replace it, so that you can keep on working with the overhaul of the carbs. I have a full video coming out soon, showing the full strip and re-build of a set of early CX500 carbs. This video is just to attend to the problem of the idle jets
Consider supporting me on Patreon if you enjoy the videos:
www.Patreon.com/RestorationBiker
Also there is a new poll every Monday on my community page so go check that out and see what you think, I will make a round up video of all results every quarter from the polls
See you next week - new videos every Monday from now on
Happy riding

[@martinowl]

I’m just in the process of removing my pilot jets, how far into the jet would you say the screw/bolt went in?

[@RestorationBiker]

Hi it should only go in by about a quarter of an inch as too far means it will be into the jet itself

[@martinowl]

@@RestorationBiker Thanks for the reply. Have managed to get the first one out, so now I can see its exact make up. Can you remember if when you looked down the jet, it looks like it is sleeved 🤔, I suppose it could be just corrosion etc, but looks a tiny orifice.

[@RestorationBiker]

@@martinowl Hi, yes I normally renew pilot jets because the orifice is so small, that it is sometimes very hard to clear them. Because (normally) they are very cheap (about £4 each) But, You can't get these ones as they are now 'unavailable' So, you have to remove them, and fully clear them. Take your time, and make sure you get them very clear.

[@martinowl]

@@RestorationBiker thanks for that 👍

[@RestorationBiker]

@@martinowl No problem, you are welcome