That’s a killer idea. We go with the hi-lift under the to rig method and it gets a bit sketchy at times 😂. Definitely going to be looking into this when ever the harbor freights near us get porta powers back in stock.
Do you think if the bottom pushed on the tire in an offset it would break easier? Basically pushing down in one spot 1st. Like a circle on an angle added to the bottom. This is really hard to explain 😂
This would have made my job of swapped tires on my beadlocks way easier, but luckily I just dropped them off at a tire shop and they did it all for me.
Сделай регулируемый шток на столе, сквозь стол, с обратной стороны стола муфту приварить с боковым отверстием, а центральную трубу сделать скользящей через муфту и стопарить втулкой насквозь
One of the most inventive solutions I’ve seen, to an annoying part of changing a tire! Have you tried this on car tires?
I built this specifically for my 17” wheels, but theoretically it would work on any similar BS 17” wheel, car or truck.
Smart work brother !
That’s a killer idea. We go with the hi-lift under the to rig method and it gets a bit sketchy at times 😂.
Definitely going to be looking into this when ever the harbor freights near us get porta powers back in stock.
I have a design in my head for something easier to make (cut file out of flat plate), but haven't sat down to design it out.
Do you think if the bottom pushed on the tire in an offset it would break easier? Basically pushing down in one spot 1st. Like a circle on an angle added to the bottom. This is really hard to explain 😂
I hear ya Mike. I think the answer is just the 10 ton kit. I’ve needed more “umph” for other projects too.
Wow tahr tyre is a little bit bigger tahr my motorcycle front tyre. Awesome!
This would have made my job of swapped tires on my beadlocks way easier, but luckily I just dropped them off at a tire shop and they did it all for me.
The first time I took 8 wheels and tires down to the local tire shop, I was instantly over it. Had to be a better way.
you got that right, I’ve been to the tire store 1, no 10 too many times already. Great solution…
Very nice. I hate breaking beads and always on the lookout for an easier method.
Good job 👍
Thank you.
Сделай регулируемый шток на столе, сквозь стол, с обратной стороны стола муфту приварить с боковым отверстием, а центральную трубу сделать скользящей через муфту и стопарить втулкой насквозь
Have you thought about going on shark tank
Hah! I don’t think it is “that” good……
Cheater bar! @7:15
Soapy water or spit