Hi, what size of a do I need for the diodes if I want to conver my motorcycle stator that pruduces only 55 watts of AC and I want to run like 30 watts of DC led lights what sept up do I need like this ?
Great project. It is rather safe because it’s isolated from the main supply and very educational and practical. It is very nicely done. Thank you for sharing.
@@danneybarr1428 then again he never provided that it puts out ac voltage. Even when he shows the meter the symbol is not clear. I doubt it was ac voltage. I have never seen ac voltage come out at 9v .
@@j.s3612 luckily the adapter part is in the video and you can google it to see that it is in fact a 9v AC output. Also the meter he's using has the waveform dislayed on it....
Cool video. How do you calculate the value of the capacitor? Another thing, how do you get a DC output of 15V when the output of the transformer is 9V Ac? Thanks for the help.
And when is biger load then biger ripple vpp. Bud whats hapen when you insered there ultra capacitours yes in series...whith zeners diods i mean. is the ripple seam
I have made a full wave bridge rectifier, using four 5408 diodes & 1000 microfarad 25V capacitor, with transformer ( 12V 4A ) but AC current is leaking on the output terminals, when i am touching the output terminals with tester then it is glowing brightly.
Please help... i have a motor that runs on 18v DC, but it will not run to my 18v AC to DC transformer.. what Diods and capacitor should i use for the rectifier?... thank you
hi, what would be the formula to calculate how many volts the conversion from AC to DC would be without a DSO150 or similar tool? Like I should be able to pull out an old AC adaptor, look at the output of it, factor in the type of diode and capacitor and get an answer no? I mean, how did people figure this stuff out on paper before digital tools where available. (If it's not obvious, I want to know because I like figuring things out on paper with nothing more than formulas _just_ because... well just because lol. Side note: I know little to nothing about electronics (if you couldn't tell by my lack of relevant terminology) but I'm good at researching until I figure it out so go easy on me if you decide to answer this question. :)
He uses 25volt since he is using an adapter that must contain a step down transformer. If you do this without the adapter you need a 400 volt capacitor. The 25 volt capacitor would go boom in an instant
@X Dtd If you don't connect capacitor, it will be fine, but you don't get DC current at the output. You need to connect capacitor so the output will be smooth DC current.
Mera daiod ac carnt me lgate hi ac ka tar hi jal ja rha hai daiod mera 1N4007 ka hai or Khali brij recti fier 4 daiod banaya hu or khuch bhi nhi lagaya hu
It can be done with 110vac but you need a Capacitor to handle the higher voltage. I believe he is just showing the principle of the project. "9v is safer for demonstration" 110v is DANGEROUS! only try if you know what you are doing.
Hello friends !
..
,,,,
Hi, what size of a do I need for the diodes if I want to conver my motorcycle stator that pruduces only 55 watts of AC and I want to run like 30 watts of DC led lights what sept up do I need like this ?
FOOOOOOOL BRIIIDGEEEE RECTIFIERRRRRRR !!!!
(Electro Booom)
so much thanks for your sharing god bless you for your mercy (donald byebye
))
Great project. It is rather safe because it’s isolated from the main supply and very educational and practical. It is very nicely done. Thank you for sharing.
FULL BRIDGE RECTIFIER
Capacitor size
Well explained ac to dc convert,and filtration through capacitor.
That way great
More power to you
Buddy"
A nice demonstration of what a capacitor does too
your explanation offull bridge rectifier is very convencing and clear keep doing
Worth video. Thank U
Well done sir very useful thanks
Nice
THE RECTIFIAAH !
Thanks you so much bro
Excellent ... well done ...
Hello brother very good thank you people
Hi, want to ask something about the Capacitor uF, what difference if I using 470uf 25V / 1000uF 25V / 2200uf 25V / 3300uF 25V
Un altro scienziato dell'elettronica. Vorrei solo chiedere a questi mostri di scienza se conoscono la legge di ohm
Какой конденсатор ставить для 12 v.? Все сам узнал. (12v) =(10000 мф. 25v)
Great
For people wanting to know the adapter he uses is AC to AC 9v it's not a DC adapter!
Can you tested it on load?
Range of capacitor?
Good
output is 9V on the charger then why it increase after the rectifier? does it supposed to step down the voltage?
Will it work on variable VAC input like AC dimmer?
👍👍👍
Wish you could show the values on a screen like you wrote (input AC), because can't read the values on phone monitor, so small
Thanks for your comment
@@CreativeAndDuck hey, i have a question.. can you use the house AC supply directly? What would happen?
Pls answer
Why is he using rectifier I don't understand. That adapter already gives dc output
First thing I noticed. What do you expect from the pajeets?
@@rootuser7206 The adapter puts out AC voltage, The "Diodes" changes it to DC and the "Capacitor" cleans up the wave to make it useable.
@@danneybarr1428 then again he never provided that it puts out ac voltage. Even when he shows the meter the symbol is not clear. I doubt it was ac voltage. I have never seen ac voltage come out at 9v .
@@j.s3612 ever used an original NES? Believe it or not its adaptor plug spit out like 9v AC also
@@j.s3612 luckily the adapter part is in the video and you can google it to see that it is in fact a 9v AC output. Also the meter he's using has the waveform dislayed on it....
I had a question, what is the screen thing called you are using, I like it.
Thats an oscilloscope
Ac and dc wave form
I know just enough to be dangerous I was just curious I always thought those plugs that say 9 volts or 12 volts was talking about DC not AC
Muito bom valeu
Is this works on 12v 1Amp or 2Amp?
Cool video. How do you calculate the value of the capacitor? Another thing, how do you get a DC output of 15V when the output of the transformer is 9V Ac? Thanks for the help.
W02 bridge rectifier will give you 15v output. But your power supply should be higher. Check the datasheet
It has to be higher voltage capacity with a margin of safety.
how can i have a 10 Amps bridge rectifier using the same diagram . Any suggestion on a diode with high rating
good sir
Can we use 2.2 uf 400v capacitor
I have 17.5v and 5 amp transformer, what diode and capacitor can i use for 14v value?
Prima data tre sa sti ce consumator vei avea; pe urma alegi diodele si condensatorul
Which poles do I use to convert from DC to AC?
You cant, you'll need an inverter to transform dc to ac
How much amps can i do?
And when is biger load then biger ripple vpp. Bud whats hapen when you insered there ultra capacitours yes in series...whith zeners diods i mean. is the ripple seam
Can use uf 4007?
best practical
Nice.. Bro
I have made a full wave bridge rectifier, using four 5408 diodes & 1000 microfarad 25V capacitor, with transformer ( 12V 4A ) but AC current is leaking on the output terminals, when i am touching the output terminals with tester then it is glowing brightly.
What is the dc output
It is very important
i need to make 4amps ,which diode to buy?
Charger. Ac output ka h kya
Where is the load? Shouldn't capacitor blow up?
Is it used for charging battery
Gak mudeng, jelaskan ding gan, sekalian... Ouput jdi brpa volt dri berpa volt, klo bsa amper sekalian
If the transformer already produces DC current, then why do you need the rectifier?
It is AC until it write DC
Transformers reduce voltage not changin ac to dc
But the output of that mobile charger is already dc voltage.
Can i use 470uf 25v sir?
Please help... i have a motor that runs on 18v DC, but it will not run to my 18v AC to DC transformer.. what Diods and capacitor should i use for the rectifier?... thank you
HOW TO ASSEMBLE SUPERCAPACITORS
Does this work as from 220v AC to 220v DC?
Yes, but only do if you know what you are doing. You will need a different Capacitor. Again "DANGEROUS" using high voltage.
This is dc to dc because you use dc power supply
What size of capacitor bring 220ac to 12dc in diodes circuit , reply soon ,valve of capacitor
I believe you need a different type of capacitor not this one, this will will explode later.
FULLL BRIDGE RECKTIFIEE! ElectroBoOM
Specification of capacitor?
What is this white instrument called as 🤔🤔
boa noite não deu pra ver o no multimetro bem e o capacitor a número favor me esprica nova mente
Isse kitne voltage ki current milti h
Bhai amp b btao kine ate h amp
bina capacitor ka hoga kya capacitor blast kar raha hai reply pls
hi, what would be the formula to calculate how many volts the conversion from AC to DC would be without a DSO150 or similar tool? Like I should be able to pull out an old AC adaptor, look at the output of it, factor in the type of diode and capacitor and get an answer no? I mean, how did people figure this stuff out on paper before digital tools where available. (If it's not obvious, I want to know because I like figuring things out on paper with nothing more than formulas _just_ because... well just because lol.
Side note: I know little to nothing about electronics (if you couldn't tell by my lack of relevant terminology) but I'm good at researching until I figure it out so go easy on me if you decide to answer this question. :)
LYTE Yearz yes there is a way, and I would like to know too!?
what Capacitor size
As per your video the DC Output showing 15.56V
If DC output needed 12V, then what is the solution?
Once you get a clean DC voltage use resistors.
7812 ic
Hello, i have one questions. 1: why do you use a 25v capacitor?
Same question.
@@johnalpherpaden3894 i wonder if you can use any voltage over the output voltage... i really want to know :(.
He uses 25volt since he is using an adapter that must contain a step down transformer. If you do this without the adapter you need a 400 volt capacitor.
The 25 volt capacitor would go boom in an instant
You can use any capacitor with higher voltage than the output of the full bridge rectifier.
@X Dtd If you don't connect capacitor, it will be fine, but you don't get DC current at the output. You need to connect capacitor so the output will be smooth DC current.
Dc out put voltage kitna hoga
Same as input 9V Dc
Sau không sử dụng đồng hồ số để hiểu ?
Mera daiod ac carnt me lgate hi ac ka tar hi jal ja rha hai daiod mera 1N4007 ka hai or Khali brij recti fier 4 daiod banaya hu or khuch bhi nhi lagaya hu
what's that brickbat soldering iron you're using?
You mean that transformer soldering iron
Rittika electronics.
Koliko je to kondenzator
How to convert ac below 110v to dc, I'm planning to build a battery charger using wind energy thanks
What the heck? You are running 9V DC into a bridge rectifier? How is this working coming from an AC to DC power brick? lol smh
1:15 AC 9V, but 4:54 AC 11.3V ??
China !
Ko yako capacitor range ekah
FOOL BRIDEG REKTIFIAH
2diode 207 ka or 2diode 4007 ka use kr skte h kya sir ...?
how bout stable 12v?
Bekub kiun banate ho rectrir banane ke smaya coponent ka oms ect kiun nehi likhte ho
Why were you using a 9v power supply. Doesn't that defeat the whole purpose of this video .
It can be done with 110vac but you need a Capacitor to handle the higher voltage. I believe he is just showing the principle of the project. "9v is safer for demonstration" 110v is DANGEROUS! only try if you know what you are doing.
@@danneybarr1428 this was my error. When I usual think of 9 v I think of dc voltage. So when I saw 9v ac I didn't believe it . But yes I do understand
Out DC
Can't see shjt
Adapter already gives dc...fool demo
No, the adapter output is AC and it's rated 9v, you can see at 1:15. But i never seen adapter like that before
Fool
It is very important