NOTE: If you want to replace the bearings in a John Deere X340 series mower, the top bearing is a non-standard NSK 6205-16 double seal bearing (25.4mm ID x 52mm OD x 15mm width). The bottom bearing is a standard 6206 double seal bearing (30mm ID x 62mm OD x 16mm width). I was able to press out the top bearing using a press with a 30 ton hydraulic jack. It made quite a loud noise when the bearing finally let go, so be prepared for that. The new bearing pressed back in without any problems, and I recreated the detents that held in the original bearing using a hammer and chisel.
NOTE: If you want to replace the bearings in a John Deere X340 series mower, the top bearing is a non-standard NSK 6205-16 double seal bearing (25.4mm ID x 52mm OD x 15mm width). The bottom bearing is a standard 6206 double seal bearing (30mm ID x 62mm OD x 16mm width).
I was able to press out the top bearing using a press with a 30 ton hydraulic jack. It made quite a loud noise when the bearing finally let go, so be prepared for that. The new bearing pressed back in without any problems, and I recreated the detents that held in the original bearing using a hammer and chisel.
How much did parts cost ?
did you say the clutch going out made the mower vibrate a lot?
not really
just noise
Bearing is 'staked' in with all those indents. You have to remove it from that side and restake the new one.
Pro tip: watch series at kaldrostream. Been using them for watching a lot of movies these days.
@Kyler Malachi Definitely, have been using flixzone} for since december myself :)
Next time....show the work.
buy a new clutch if the bearings are bad the rest of clutch is not far behind being worn out.
Price a new clutch lately?