Steve, at 5:50, when you set up 3 curves each selected by one switch position, isn't it simpler (and same result) to have one curve and set input to "Switch A" in general (not a specific position of Switch A)? I have mine set up this way, and I don't see any difference in end result. I can edit the three points, and Switch A moves the output across those three points on one curve. Maybe there is some benefit to having 3 flap curves and using only 1 of the three points on each curve (as shown in the video), but if so I'm not understanding what that benefit is.
Is there a way to add flap trim? Like an elevator/flap trim mix so it can be adjusted in flight? Also it would be nice to be able to trim roll as well for each flap setting like on Jetti. Thanks!!
Why are you only using half the servo travel? If I were setting this up, the flap curve would be 3 points, -100 and 100 on the ends, and the middle point somewhere between the two, depending on how much I wanted for my intermediate flap setting.
Exactly my thoughts, I’ve never setup flaps how he did in this video with only using 50% of the flaps available travel. One end is going to have a mechanical advantage and the other end not.
Hi Steve, Nice tutorial. Your last mod. You forgot the time changes as well. As you leave it 1sec down up 2,5 sec. This is not ehat you ehish down 2,5 sec and up 1 sec, right?
Great video Steve! Could we see how to add in the elevator mix with the flaps and how to slow the elevators movement to match the slowed flaps?
Great Job as always Steve!
what about trimming elevator during flight for mid and full flaps?
Great video Steve, but how do you add an elevator mix with flaps down and can you change the amount of down elevator in that mix if you need to.👍
I'm loving this simulator lol. I'd like to see a video on setting up the Trainer system.
Steve, at 5:50, when you set up 3 curves each selected by one switch position, isn't it simpler (and same result) to have one curve and set input to "Switch A" in general (not a specific position of Switch A)? I have mine set up this way, and I don't see any difference in end result. I can edit the three points, and Switch A moves the output across those three points on one curve. Maybe there is some benefit to having 3 flap curves and using only 1 of the three points on each curve (as shown in the video), but if so I'm not understanding what that benefit is.
Is there a way to add flap trim? Like an elevator/flap trim mix so it can be adjusted in flight? Also it would be nice to be able to trim roll as well for each flap setting like on Jetti. Thanks!!
Good morning Steve
Great video however on my Turbo Timber I haven’t been able to get my flaps back to full off. What am I doing wrong?
Just getting to setup flaps on Ethos for 1st time - tks! Hey, is this simulator available from the Ethos app on Mac?
Sorry, I believe it's PC only.
Why are you only using half the servo travel? If I were setting this up, the flap curve would be 3 points, -100 and 100 on the ends, and the middle point somewhere between the two, depending on how much I wanted for my intermediate flap setting.
Exactly my thoughts, I’ve never setup flaps how he did in this video with only using 50% of the flaps available travel. One end is going to have a mechanical advantage and the other end not.
E come si fa a miscelare anche il timone di profondità per dare un pò di picchiata a contrastare l'effetto cabrante quando di inseriscono i flaps?
Hi Steve,
Nice tutorial. Your last mod. You forgot the time changes as well.
As you leave it 1sec down up 2,5 sec. This is not ehat you ehish down 2,5 sec and up 1 sec, right?
Good video, but get to the point...