How to Replace Front Wheel Hub Bearing 2008-2010 Ford F-250

Buy Now!
New Wheel Bearing & Hub Assembly from 1AAuto.com 1aau.to/ia/1ASHF00208
This video shows you how to install a new wheel hub and bearing on your 2008-2010 Ford F-250. Not only can a worn wheel bearing or hub be annoying if it is noisy or vibrating, but it can also lead to accelerated wear in other parts, or unsafe driving conditions. Replacing your worn bearing or hub with a quality TRQ part is a safe, smart, decision.
This process should be similar on the following vehicles:
2008 Ford F-250 Super Duty
2009 Ford F-250 Super Duty
2010 Ford F-250 Super Duty
Tools you will need:
• 21mm Socket 1aau.to/o4J/1AXAA00043
• Snap Ring Pliers
• Straight Cutters
• 1/2 Inch Impact Gun 1aau.to/oox/1AXAA00252
• T27 Torx Socket
• Ratchet 1aau.to/obiw/1AXAA00016
• Torque Wrench 1aau.to/oaoW/1AXAA00044
• sanding disc
• Hammer 1aau.to/oMC/1AXAA00091
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money

[@sonnylewis5880]

What snap ring pliers were used? I’ve been at it for 3 days and snapped 3 sets of snap ring pliers

[@MichaelPenick-im1hx]

Thank you so much

[@patriciareynolds2729]

i think u should replace crossbearing and oilseal if going this far!

[@KdoeG]

Do you have to replace both hubs if just 1 is bad

[@lalozichlids3245]

What pliers did you use to remove the o ring?

[@handyscapersllc]

10:44 try not to get it on the studs 😂

[@Cutlerylover4life1]

that truck looks like it worked in a salt factory

[@mikegomez5796]

Bro not enough review on this part. Priced well but just no review ..... Good video by the way

[@TRQ]

+Mike Gomez Thanks for watching our video! 1aau.to/m/Shop-TRQ