I noticed you didn't have cotter pins on the release shaft were the springs are located. Do they not need to be on there? They were a PITA to get them out.
How about doing a video on how to Level the Cutting Deck on a RZT 50 series? I have followed the manual instructions, but feel like there might be an easier way to do it than how I'm doing it. Thanks
Make sure your spindles are not damaged. Usually with just one cutting off the spindle has been damaged, or the blades warped. Considering this is a 2 year old video, I'm sure you have it fixed by now, just maybe it helps the next person.
Very helpful. Especially pulling back the idler.
I noticed you didn't have cotter pins on the release shaft were the springs are located. Do they not need to be on there? They were a PITA to get them out.
how do you keep the belt one thefront pulleys in place while tightening the rear one, by yourself? They keep falling off. thanks!
tape
How about doing a video on how to Level the Cutting Deck on a RZT 50 series? I have followed the manual instructions, but feel like there might be an easier way to do it than how I'm doing it. Thanks
Leslie B should go on ur idler pulley
roostershooter76 tell me about I have RZT 50 it all my blades cut at different lengths. I think my spindles are bent or the deck itself.
Make sure your spindles are not damaged. Usually with just one cutting off the spindle has been damaged, or the blades warped.
Considering this is a 2 year old video, I'm sure you have it fixed by now, just maybe it helps the next person.
@Les Fernandez ????? I? place?? I?
I have no clue where the tension spring gets reattached??
You did not re attach the front deck lift rod in the video.
I need a deck in CT
This is the one huge design flaw with these machines. Very primitive design.
Does the author ever respond to comments?
Bro is of no help in terms of replying to comments💀