You're doing it okay but not the right way always use a little if you need to take those out of the drum take him out you were hitting the bottom that's the reason why you have to use the press could have done without the press if you had just put something on each side please take this, with respect 🔧
Thank you so much for this video متشکرم از شما آقای محترم
Seen a lot of bearing vids this looks like my setup thanx
No Grease on the spindle before install of the bearing and drum?? No Torque wrench to install Nut?
Any advice on a stubborn dust cap?
Tap them out with s hammer. If they break, buy new ones or tap them round again.
was you getting a knocking sound before you changed the bearing
Roaring noise
Do you pack extra grease in the dust cap?
Not on this type, no.
You're doing it okay but not the right way always use a little if you need to take those out of the drum take him out you were hitting the bottom that's the reason why you have to use the press could have done without the press if you had just put something on each side please take this, with respect 🔧
Exle nut size?
29mm
@@scottthebarber 30mm
More like an 08
It's no newer than a 2006