ฝัง
- เผยแพร่เมื่อ 5 พ.ย. 2023
- This is earlier when I was working on the BLDC motor and some of the steps I went through, showing what I had to go through. Hopefully, you can watch and know what you're up against that way.
There's a lot of things I don't know About other ways of hooking it up, but if you do it The way I did it should work great.
parts available at my store
stock202.company.site/
Good luck with your project and god bless.
Excellent work by the way!!!! And thank you for open sourcing. How and what connections did you use to connect the motor pulley to the front of the rotor?
I lined up the factory holes and bolted it to that pully u see, then drilled 3 more holes in the pully inline with the factory holes used for their plastic piece.
All these videos, you might see some slight hesitation on my side.
I only got the three bolts in there and one Allen screw to the shaft, just waiting for that thing to fly off of there is have the fun.
I'll add 2 Allen's and 6 bolts.
Just bolts and washers and drilling. Make shur it center and then make shur its centered, dubble ✔️ ✅️.
CAN you give details of controller brand, model, source and ALLA INFORMATION TO DUPLICATE your success! Thanks in advance. I have one of these motors ready to test.❤
Yes I thought I did in the other videos. It is also available here stock202.company.site/
That is the like to the site I made to source them paypal let's people make payments so it's the most affordable way I could find to get these in people hands. There you will find a detailed list of the controllers functions.
I will do a follow-up video for further tests like heat and stall etc.
Did you install hall sencors and if so how do calibrate where to put?
Did you rewire it at all? I've got it spinning using 12 volt ESC's but I had to rewire it into paralkel groups of 3's in y configuration, if you rewired it like I did I bet the red brick ESC you have would work for it.
Yes, I did, but when I used the red brick, I didn't clean the wires good enough beforehand. With the new controller and clean wire contacts, I'm able to supply & make adjustments for more power.
I believe these might have even more potential, tho.