THANK YOU, DR LOCK ... I HAVE THIS TOOL IT SAVES YOU A LOT OF TIME . MY ONLY QUESTION WITH THIS TOOL IS, ONE TIME I WAS TESTING A 2012 I THINK NISSAN NOTE, AND WHEN I TURNED THE KEY TO THE ON POSITION THE LIGHT STAYED ON . AT THE TIME I WAS CALLED IN TO CHECK THIS CAR FOR A NO START IT WOULD CRANK BUT WOULD NOT START, NOT SORE AT THIS TIME BUT I THINK I SAW KEY CODES . BUT THE CAR WAS SENT TO THE DEALER SO I DON'T KNOW WHAT BECOME OF IT . THANKS AGAIN FOR TAKING YOUR TIME AND SHOWING US ALL THIS COOL TOOL.
Reprogram the key into it, it could be a bad ECU , then do a full scan, I have seen the same on the elgrand, maybe a solid light is its picking up the transponder but its not matched, Just a thought, a full scan may tell u more
Thank you Dr. I bought one. The light comes on but it's not as bright as yours. I suspect the copper coil in the immobilizer was tampered with when removing the key cylinder. Seen ppl wrap extra copper wire around the immobilizer to amplify the signal. Have you ever come across anything like this before?
I hand these out like candy. Any time I get asked to look at a key fault at a dealer, auto elechicken, RACV / RACQ etc task, I give the technician one of these. Handy little toolbox tool, and if you put a branded keytag on it, they'll always have your contact detail.
Would be great if you demonstrated another way, one like you did... With the proper key and With a blank or unprogrammed key... appreciate the knowledge. I have one on order.
What I'm guessing is if the key is not programmed the light may blink, stop, blink again... while the immobilizer coil continues to search for a properly programmed key. All in all good demostration.
Hi I have tested my ford fiesta 2011 with one of these. The Car is no start, no crank. The led just stays lit once ignition is turned. And also get no key signal detected. What are the chances it being the transponder ring? How do you test the signal wires with a multi meter ? Thanks in advanced
THANK YOU, DR LOCK ... I HAVE THIS TOOL IT SAVES YOU A LOT OF TIME . MY ONLY QUESTION WITH THIS TOOL IS, ONE TIME I WAS TESTING A 2012 I THINK NISSAN NOTE, AND WHEN I TURNED THE KEY TO THE ON POSITION THE LIGHT STAYED ON . AT THE TIME I WAS CALLED IN TO CHECK THIS CAR FOR A NO START IT WOULD CRANK BUT WOULD NOT START, NOT SORE AT THIS TIME BUT I THINK I SAW KEY CODES . BUT THE CAR WAS SENT TO THE DEALER SO I DON'T KNOW WHAT BECOME OF IT . THANKS AGAIN FOR TAKING YOUR TIME AND SHOWING US ALL THIS COOL TOOL.
Reprogram the key into it, it could be a bad ECU , then do a full scan, I have seen the same on the elgrand, maybe a solid light is its picking up the transponder but its not matched, Just a thought, a full scan may tell u more
THANKS SO MUCH FOR THE REPLY, I WILL REMEMBER THIS ADVICE IN THE FUTURE AND OF COURSE LET YOU KNOW !!!!!!!!!
Thank you Dr. I bought one. The light comes on but it's not as bright as yours. I suspect the copper coil in the immobilizer was tampered with when removing the key cylinder. Seen ppl wrap extra copper wire around the immobilizer to amplify the signal. Have you ever come across anything like this before?
I hand these out like candy.
Any time I get asked to look at a key fault at a dealer, auto elechicken, RACV / RACQ etc task, I give the technician one of these.
Handy little toolbox tool, and if you put a branded keytag on it, they'll always have your contact detail.
That's a good idea
@@DrLockShop so this would basically let me know whether or not the car also has a transponder system or not
WHERE CAN I GET ONE...WHAT IS IT CALLED?
So what if the led does not blink? Would it be a bad transponder or a vehicle wiring issue?
Would be great if you demonstrated another way, one like you did... With the proper key and With a blank or unprogrammed key... appreciate the knowledge. I have one on order.
the light can't tell you if the key is programmed or not.
What I'm guessing is if the key is not programmed the light may blink, stop, blink again... while the immobilizer coil continues to search for a properly programmed key. All in all good demostration.
@@thelocallocksmithcompany-t9164 don't know how many times it'll ask if theres a transponder, but it isn't more than 1 window per key turn.
@@georgeblair7129 understandable
Hi I have tested my ford fiesta 2011 with one of these. The Car is no start, no crank.
The led just stays lit once ignition is turned.
And also get no key signal detected.
What are the chances it being the transponder ring? How do you test the signal wires with a multi meter ?
Thanks in advanced
Hi DrLock can you uplod video how work cheap VDIAGTOOL VT600 tool key programmer?😀
no , we cant because we dont have one
nic