I have brought many a mower back to life . The first thing i do is, engine cover off and check to see if any pest have made a home or chewed on any wires,only then will i start working on getting it to run.When i service any mower I always pull the engine cover just to check,it,s not that hard or time consuming and can prevent a burn up engine.Not just mice, mud dobber wasp love to build nest between the heat fins. Engine can,t dissipate heat correctly won,t last very long.
You have to connect the positive battery wire positive battery terminal and connect the negative to the negative battery post that’s how I do it when working on lawnmowers
The biggest thing is to use good quality belts like stens and there really long lasting if it’s serviced regularly Oil and filters are dirt cheap and I charge oil every 20/25 hours no matter what 😊
I'd give you a thumbs up and possibly subscribe, but the music completely detracted from everything you did. On this kind of video I'd much rather hears the sound of wrenches than music. You seem to have a nice shop and your stepwise method of getting this mower running was quite good, but I muted it after about six minutes.
@@BlueCollarCompendium Thank you. Honestly, the only time I think music is appropriate in "mechanical" videos such as this is when the recording is played back at a higher speed, where the sound would be jibberish. Your video skills are quite good, so let your commentary, the sounds of tools working and water splashing help to tell the story.
Great job man you just got to watch out how much you use the choke on those single cylinder Briggs, the kohler singles are even worse but one this with those Briggs singles is that the compression release on the camshaft goes bad on 70% of them and it almost seems like week starter or battery
The compression release mechanism on the camshaft very rarely breaks. Do not listen to the above post. I have replaced 2 total from hundreds of engines I have worked on.
your video was inspiring and interesting. your work area is immaculate almost sterile. being a life long mechanic for 60 years, i noticed one important thing that was questionable. when you replaced the battery, you disconnected the positive cable first. Granted the battery had low voltage which you checked prior to disconnecting it, and wasn't important or dangerous, but after placing the new battery fully charged backwards (oops) you proceeded to install the negative cable first and then the positive cable using metal wrenches in an area that was surrounded by metal. this is sometimes dangerous (sparking or worse as damage could occur to a system that was on). Your video was great and if I was still teaching automotive repair, I would USE IT AS A TEACHING AID, it was that good. I was impressed by everything i saw including the securing of the mower and the clean up of a rental trailer. this is not criticism meant to offend, but some people who watch these videos are probably less skilled than you, and would follow your approach to repairs as gospel. Thank you for making this video, you are professional and knowledgeable. i wish I was motivated to keep my work area as nice as yours, but sadly mine is a disaster. Thank you for setting the bar so high, I am going to wash my John Deere mower, as soon as I finish this note. Bill B
In regards to my work area, I have a hard time staying focused if my bench is too cluttered however, some of the best mechanics Ive ever had the pleasure of working with haven't seen the top of their bench in years!
I really enjoy rebuilding riding mowers, it’s still fun being a diesel mechanic and having fun at 73 😊
I have brought many a mower back to life . The first thing i do is, engine cover off and check to see if any pest have made a home or chewed on any wires,only then will i start working on getting it to run.When i service any mower I always pull the engine cover just to check,it,s not that hard or time consuming and can prevent a burn up engine.Not just mice, mud dobber wasp love to build nest between the heat fins. Engine can,t dissipate heat correctly won,t last very long.
Next time if any lawn mowers have been sitting in a barn wash them and clean the fuel tank it will make seeing the gas better. Wow u r a rookie
Haha Yep, that was my first video. I wouldn't call myself a lawn mower expert. Thanks for the tip.
Very nicely done...not much wrong with that mwer at all
Yep I'm blessed it wasn't rusted out.
I'm going to be hearing that guitar music in my sleep for days....please make it stop! lol
You have to connect the positive battery wire positive battery terminal and connect the negative to the negative battery post that’s how I do it when working on lawnmowers
The biggest thing is to use good quality belts like stens and there really long lasting if it’s serviced regularly
Oil and filters are dirt cheap and I charge oil every 20/25 hours no matter what 😊
I haven't used Stens belts before. I'll have to look them up.
@@BlueCollarCompendiumthere very good and work great on the old VS system
and yes the music is distracting
I'd give you a thumbs up and possibly subscribe, but the music completely detracted from everything you did. On this kind of video I'd much rather hears the sound of wrenches than music. You seem to have a nice shop and your stepwise method of getting this mower running was quite good, but I muted it after about six minutes.
Noted, I have since toned down the music alot.
@@BlueCollarCompendium Thank you. Honestly, the only time I think music is appropriate in "mechanical" videos such as this is when the recording is played back at a higher speed, where the sound would be jibberish. Your video skills are quite good, so let your commentary, the sounds of tools working and water splashing help to tell the story.
Great job man you just got to watch out how much you use the choke on those single cylinder Briggs, the kohler singles are even worse but one this with those Briggs singles is that the compression release on the camshaft goes bad on 70% of them and it almost seems like week starter or battery
Why do I need to watch house much I use the choke?
The compression release mechanism on the camshaft very rarely breaks. Do not listen to the above post. I have replaced 2 total from hundreds of engines I have worked on.
hi, a little cleaning before working on the tractor would have been cleaner don't you think!!!!!!!!!!!!!!!!!!!!!!
your video was inspiring and interesting. your work area is immaculate almost sterile. being a life long mechanic for 60 years, i noticed one important thing that was questionable. when you replaced the battery, you disconnected the positive cable first. Granted the battery had low voltage which you checked prior to disconnecting it, and wasn't important or dangerous, but after
placing the new battery fully charged backwards (oops) you proceeded to install the negative cable first and then the positive
cable using metal wrenches in an area that was surrounded by metal. this is sometimes dangerous (sparking or worse as damage
could occur to a system that was on).
Your video was great and if I was still teaching automotive repair, I would USE IT AS A TEACHING AID, it was that good.
I was impressed by everything i saw including the securing of the mower and the clean up of a rental trailer.
this is not criticism meant to offend, but some people who watch these videos are probably less skilled than you, and would
follow your approach to repairs as gospel. Thank you for making this video, you are professional and knowledgeable. i wish I was
motivated to keep my work area as nice as yours, but sadly mine is a disaster. Thank you for setting the bar so high, I am going to wash my John Deere mower, as soon as I finish this note. Bill B
Disconnecting batteries is very infrequent for me. I wouls say I do it correctly 50% of the time. Thanks for the help.
In regards to my work area, I have a hard time staying focused if my bench is too cluttered however, some of the best mechanics Ive ever had the pleasure of working with haven't seen the top of their bench in years!
so your idea of a "restoration" is a new battery, fuel and filter ?
Enjoyed the video and your methods, but honestly, the music has to go, doesn't do anything for the video.
You obviously don’t know how to disconnect a battery properly, ground comes off first and goes back on last so you don’t short it with your wrench
I didn't watch the video because the silly background music was driving me nuts
Get rid of the crappie music
I totally agree. Gets annoying quick.
Same hearing the stum of the guitar for a long time gets annoying after 3.4 seconds
TOTALLY AGREE!!!!!
Obnoxious "tune"!
Too d*mn LOUD!!
Turned off video after a very few minutes ..... don't know if you EVER got it running!!!
😬😬😬
Same short piece of music over and over a very very boring
Stup1d fuc*ing music
NEED TO DITCH THE MUSIC, VERY ANNOYING!