If that retaining clip is hard to loosen/corrosion welded to the plate, you can look through one of the air vents on the side and tap the clip with a thin screwdriver. Likewise, when reassembling, you can peek through the vent holes and make sure it isn't blocking the reinsertion of the armature.
It depends on the size of the job. If I'm only doing this... 250.00. Sometimes, the bearings are hard to get or expensive. Remember to judge whether the job is worth it or not.
Thanks for the video.
You're welcome
Thanks for the video 👍
Thank you!
Very helpful video indeed. Getting the shaft out of the housing is a major head-ache. I used a lot of patience and WD-40 and a rubber mallet...
Useful info, but not a smart work surface.
Perfect for my shortness
You lost the spacers
I use the old bearing to sit on top of the new bearing and then bang it on
If that retaining clip is hard to loosen/corrosion welded to the plate, you can look through one of the air vents on the side and tap the clip with a thin screwdriver. Likewise, when reassembling, you can peek through the vent holes and make sure it isn't blocking the reinsertion of the armature.
Can I use my old bearings from my old pump if they r the same exact pumps?
If they're in good condition, of course. New bearings are usually pretty inexpensive though.
New ones are so cheap why would you? Why repair with bad parts?
Where did you get the bearings
Amazon.
I got my women power. Gracias
Your video was super helpful,I appreciate it.
What is the cost to rebuild one of those ?
It depends on the size of the job. If I'm only doing this... 250.00. Sometimes, the bearings are hard to get or expensive.
Remember to judge whether the job is worth it or not.
This is a poor excuse on showing people how to replace brgs u didnt dhow anything about the govenor switch
There is no governor switch. Single speed? Single capacitor.