sounds like it could be a controll board not sensing the motor speed. or you could have changed the settings as there's a auto stop in reverse. a few different settings are changed by a sequence of button presses. check the instructions
Hi i have a DTW285 with a problem, when you press the switch it judders sometimes doesn't turn at all then occasionally starts to work, could it be the switch?
Got a pile of these. I have to replace them for the same problem every 5-6 month. They start screeching and stop unwrapping/ wrapping fittings. Does it need new parts or just cleaned. Had a look all the cogs have there teeth still.
Hi mate, i have the 300z. Horrid screetch noise when pressing on the trigger ( not 100% on the correct name of the parts) i thought the rear fan bit was broken so i bought a new one, still the same noise.. how do i diagnose the problem without buying loads of wrong parts and end up spending close to what a new one would cost. Thanks pal
it's a hard one to diagnose but a screeching could be the gear box or bearing sized up. try to listen to where it's coming from. give it a good clean and a set of brushes
you should service them yourself all parts are available to buy. and it would save you the cost of a new one. At least you could just buy 1 a year. this was from a scaffolding company picked up 5 of them.
![makita / Cordless Impact Wrench / DTW285 [ Retro Tool years 2017 ]](http://i.ytimg.com/vi/6qowl0MKl38/mqdefault.jpg)
Hi mate I was wondering I have a dtw300 when you put it in reverse start like couple of seconds then stops any ideas ? Thanks
sounds like it could be a controll board not sensing the motor speed. or you could have changed the settings as there's a auto stop in reverse. a few different settings are changed by a sequence of button presses. check the instructions
Full strip down clean and it’s fully working away order full case and plastic nose cone cheers mate for your help
Hi. What type of grease is this please? Really struggling to find any information. Thanks
Hi i have a DTW285 with a problem, when you press the switch it judders sometimes doesn't turn at all then occasionally starts to work, could it be the switch?
Got a pile of these. I have to replace them for the same problem every 5-6 month. They start screeching and stop unwrapping/ wrapping fittings. Does it need new parts or just cleaned. Had a look all the cogs have there teeth still.
Hi mate, i have the 300z. Horrid screetch noise when pressing on the trigger ( not 100% on the correct name of the parts) i thought the rear fan bit was broken so i bought a new one, still the same noise.. how do i diagnose the problem without buying loads of wrong parts and end up spending close to what a new one would cost. Thanks pal
it's a hard one to diagnose but a screeching could be the gear box or bearing sized up. try to listen to where it's coming from. give it a good clean and a set of brushes
hi mate i dropped my drill and now no battery gives it power could you diagnose?
How much would you charge for a full refurbishment??
I go through 2 of these a year scaffolding.
Could do with saving a few quid nowadays.
you should service them yourself all parts are available to buy.
and it would save you the cost of a new one. At least you could just buy 1 a year. this was from a scaffolding company picked up 5 of them.