After all the research i found on how to remove these window cranks i decided to do a video to show how easy but complicated these cranks are.. Hope it helps
It’s similar for a mk2 2013 Kia Cee’d. I used the 90 degree end of a scribe tool to pick it out. Had the window lever pointing upwards and pulling out enough towards me to reveal the edge of the clip. Thanks for showing what’s going on in there. 👍
Looked up many videos on how to take out the stupid window crank! actually purchased a tool that is meant to take out the pin with NO LUCK. I purchased the exact tool you used here and with your directions I was finally able to to it! Thanks for posting this! 100 Likes! I wish Hyundai just used a screw with a screw cover instead of making this removal so complicated!
2013 UK Hyundai i10 rear window crank ....... I found I could push the clip off from its end . small screw driver with a bent end , push between door card & washer . pushing away from the crank handle, pushes it out from its slot ... Thanks for the video for showing what we are up against ... .... FYI ... the 3 clips at the back of the rear door, were in my case a super strong white clip which broke the door card rater than pulled out . the 3 clips at the bottom were yellow & pulled out nicly.
I have a 2002 Accent, and I didn’t have a tool like yours, so I used one of the attachments on my Leatherman, and I pushed one of the opposite ends to what you pried loose, and it popped out. Can you please tell me the name of that tool?
The circle actually spins independently from the clip as the slots the clip rides in are part of the handle. The circle is just for esthetics and of course to make it harder to get the clip out.😂
Korbę szyby ściąga się bez użycia narzędzi😊😊😊haczyków, podważania itd. Dotyczy to większości aut ze spinką omega. Ile trwa to na filmie? :-) Amator robi to w dwie sekundy. Co na to mechanicy? :-)
They make an actual window crank tool or you can go to harbor freight and get a cheap set of pick tools and do what i did in the video to pull out the pin to adjust the crank lever or remove it
thanks, the back in had me confused on the other video i watched. most vehicles are the same. i was watching for an 05 dodge dakota. Window rattle and it need a mirror that doesn't jiggle every time i hit a bump. How i miss my 04 Dakota. slightly better made all the way around. some idiot on a cell phone crunched me from behind at a red light and totaled it. I can't stand people who can't leave the phone alone while driving. Geeze, you go to prison for killing people if it was your fault.
It’s similar for a mk2 2013 Kia Cee’d. I used the 90 degree end of a scribe tool to pick it out. Had the window lever pointing upwards and pulling out enough towards me to reveal the edge of the clip. Thanks for showing what’s going on in there. 👍
Looked up many videos on how to take out the stupid window crank! actually purchased a tool that is meant to take out the pin with NO LUCK. I purchased the exact tool you used here and with your directions I was finally able to to it! Thanks for posting this! 100 Likes! I wish Hyundai just used a screw with a screw cover instead of making this removal so complicated!
I agree,, thanks for the love!!
Juan - looses???
2013 UK Hyundai i10 rear window crank ....... I found I could push the clip off from its end . small screw driver with a bent end , push between door card & washer . pushing away from the crank handle, pushes it out from its slot ... Thanks for the video for showing what we are up against ... .... FYI ... the 3 clips at the back of the rear door, were in my case a super strong white clip which broke the door card rater than pulled out . the 3 clips at the bottom were yellow & pulled out nicly.
The Hyundai's get me every time.. thanks
Thank you so much. I broken the piece plastic because no have the tool but thank you I can't take off the handless
Thanks, very helpful
I have a 2002 Accent, and I didn’t have a tool like yours, so I used one of the attachments on my Leatherman, and I pushed one of the opposite ends to what you pried loose, and it popped out.
Can you please tell me the name of that tool?
@@MrWoodstar1 I used an orange pick tool and a red panel popper, pretty cheap grab at your local Harbor Freight or Amazon..
Actually, it looks like that plastic raised up area is the detent for the clip. So look for it on opposite side of crank.
The circle actually spins independently from the clip as the slots the clip rides in are part of the handle. The circle is just for esthetics and of course to make it harder to get the clip out.😂
The tool being used is a Hose Pick Tool
in my case the clip was between window crank and plastic circle X( not ease without that tool that you use, but thanks for showing
what is the tool called that you used to take the pin out?
Just a 90 degree pick tool
Korbę szyby ściąga się bez użycia narzędzi😊😊😊haczyków, podważania itd. Dotyczy to większości aut ze spinką omega. Ile trwa to na filmie? :-) Amator robi to w dwie sekundy. Co na to mechanicy? :-)
Thank you
Do you have a link to that exact tool? Thank you
No i don’t,, try harbor freight or your local hardware store
Good job
Made it way easier then using a thin hand rag lol
Delbert Harris glad i could help!
Than
Delbert - THAN
Thanks
Ou tu as acheter outil pour demonter
Holy crap. I have to buy a tool just to adjust the position of the crank?!?
They make an actual window crank tool or you can go to harbor freight and get a cheap set of pick tools and do what i did in the video to pull out the pin to adjust the crank lever or remove it
@@UpsideDownKid222 Thanks, Tony!
Anaku ja bisa buka it bosss😂😂😂😂
En français svp😅😊
thanks, the back in had me confused on the other video i watched. most vehicles are the same. i was watching for an 05 dodge dakota. Window rattle and it need a mirror that doesn't jiggle every time i hit a bump. How i miss my 04 Dakota. slightly better made all the way around. some idiot on a cell phone crunched me from behind at a red light and totaled it. I can't stand people who can't leave the phone alone while driving. Geeze, you go to prison for killing people if it was your fault.
monmixer 💯
This video is almost helpful. Nohing could remove the metal thing, had to break the handle and even then it was fucked. Hate this fucking car
do not try this on a new Car
What a f***in nightmare.
James Erikson it can be yes, hope it helped though
the longest in the world 🇬🇸
They’re not called Jesus clips for nothing! “Jesus it almost took my eye out! Now where did it go?” 😂
@@twowheels808, that's fkn hilarious!! 🤣 😂