Sturdy dial indicator holder 1
ฝัง
- เผยแพร่เมื่อ 16 ก.ค. 2024
- I'm starting to make a simple but sturdy dial indicator holder.
First, I make a differential screw with which the holder is tightened in place.
I got the idea for this holder from Stefan Gotteswinter: @StefanGotteswinter
Stefan got his idea from Robin Renzetti: @ROBRENZ
Both channels contain a lot of practical information about precise machining.
In this video I use:
- Weiler Matador SV (1972) Lathe
- Solberga (1975) Drill press
Chapters:
00:00 Opening animation
00:45 Introduction
03:32 Materials and tools
05:45 Facing, center hole and start of turning the outer diameter
10:21 10 millimeter outer diameter turning
16:01 8 mm outer diameter turning
18:49 Parting off the workpiece
21:20 Shaping the round end
26:16 Making an M10 x 1 thread with a thread die
29:01 Making an M8 x 1.25 thread with a thread die
31:43 Drilling a hole and installing the handle
39:23 Final words
The video is spoken in Finnish but it has good quality hand written subtitles in English, German and Finnish. - วิทยาศาสตร์และเทคโนโลยี
Thanks Fino, for doing this again with the drawings in the back. I,ll go along with you in the proces.
Hyvät työvaihetta havainnollistavat piirustuksen pyörivät kuvassa työn edetessä ja opettavaista tiedot nopeuksissa ja syötöstä kuten ennenkin. Kiitos
good video finno ugric
Vähän oikomista tehdä pakalla kierre. Johonkin toisarvoiseen tulee joskus tehtyä.
Sopivassa paikassa laiskuus on hyvä juttu.