Ah, yes, nearly everything is discounted😉…at least most Stihl parts are only a few days away here…a lot of Husqvarna parts are back ordered a few months.🙄
@@jimssawsnstuff8903 well you're really lucky as my local saw shop (they peddle both Stihl & Husqy) are the worst to deal with -- they'll give you the yayaya we'll order it for you and give you a call when it arrives. Radio Silence....
@@902hand7 I mostly deal with a mid-sized Stihl and Echo shop, they bill me when I pick it up. When I need Husky stuff it’s a larger shop that bills before they order…
I just changed out one of those frayed harnesses causing a no start, swapped it out and now it idles fine and dies when you full throttle. You can blimp it until it shuts off. Leaning toward solenoid or the ignition coil now. Saw has been out of service for a while
Hi! I´ve upgraded my 201 with the "carving kit". The springs are much stiffer and give you much more control. spring: 1145 791 3101 AV elements: 1145 790 8303 and 1145 790 9902. Then I glued a stripe of rubber (5 mm) to the body right under the front handle near the wires to limit the movement of the handle. Works good so far. Greetings from Germany!
Great info Jim. And lemme guess - Stihl is practically giving those wiring harnesses away if a fella needed to replace it... 😉😉
Ah, yes, nearly everything is discounted😉…at least most Stihl parts are only a few days away here…a lot of Husqvarna parts are back ordered a few months.🙄
@@jimssawsnstuff8903 well you're really lucky as my local saw shop (they peddle both Stihl & Husqy) are the worst to deal with -- they'll give you the yayaya we'll order it for you and give you a call when it arrives. Radio Silence....
@@902hand7 I mostly deal with a mid-sized Stihl and Echo shop, they bill me when I pick it up. When I need Husky stuff it’s a larger shop that bills before they order…
I just changed out one of those frayed harnesses causing a no start, swapped it out and now it idles fine and dies when you full throttle. You can blimp it until it shuts off. Leaning toward solenoid or the ignition coil now. Saw has been out of service for a while
Fuel solenoid and filter come as a kit, definitely a place to start…replace them, then try a m-tronic reset.
Hi! I´ve upgraded my 201 with the "carving kit". The springs are much stiffer and give you much more control. spring: 1145 791 3101
AV elements: 1145 790 8303 and 1145 790 9902.
Then I glued a stripe of rubber (5 mm) to the body right under the front handle near the wires to limit the movement of the handle. Works good so far.
Greetings from Germany!
Thanks for the info! Please like and subscribe, if you haven’t. It would be nice to have you along 😎👍
I have the same problems 😄🙋🇷🇴