How to Replace Crank Sensor 2005-2010 Chevrolet Cobalt
ฝัง
- เผยแพร่เมื่อ 11 ก.ย. 2024
- Buy Now!
New Crankshaft Position Sensor from 1AAuto.com 1aau.to/ib/1AEC...
This video shows you how to install a new crankshaft position sensor on your 2005-2010 Chevrolet Cobalt. The crankshaft position sensor is an important component of any electronically controlled ignition system. The sensor provides the computer with data about the position of the crank shaft to properly adjust ignition timing. If the sensor in your vehicle is broken or malfunctioning, you may suffer poor performance, or get a check engine light.
This process should be similar on the following vehicles:
2005 Chevrolet Cobalt
2006 Chevrolet Cobalt
2007 Chevrolet Cobalt
2008 Chevrolet Cobalt
2009 Chevrolet Cobalt
2010 Chevrolet Cobalt
Tools you will need:
• Pocket Screwdriver
• 10mm Socket 1aau.to/orb/1AX...
• 13mm Socket 1aau.to/oun/1AX...
• 15mm Socket 1aau.to/oun/1AX...
• 6mm Socket 1aau.to/orb/1AX...
• 8mm Socket 1aau.to/orb/1AX...
• 3/8 Inch Drive Ratchet 1aau.to/oun/1AX...
• Ratchet 1aau.to/ov6/1AX...
• Socket Extensions 1aau.to/oun/1AX...
• Swivel
• Torque Wrench 1aau.to/ons/1AX...
Subscribe: / @trq
Check out our playlist:
Chevy Cobalt 2005-2010 1st Generation: • Chevy Cobalt 2005-2010...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money
Thanks you for taking your time to help us,very useful and practical
I mean it would help if you had a better camera angle. Also showing exactly where this would help too.
Much easier to reach from the top. It is right under oil filter.
I'm about to do this today and I am thinking about going from the top... do you think I can do it after just pulling the supercharger or do I have to remove more?
Will this require needing to relearn the crankshaft position?
is it the same for a pontiac g5
How come it pops in but mines doesnt