SYMPTOMS OF A BAD FUEL RAIL PRESSURE SENSOR P0190 P0191 P0192 P0193 P0194 CODES

แชร์
ฝัง

ความคิดเห็น •

  • @jamesgregory7089
    @jamesgregory7089 11 หลายเดือนก่อน +3

    This video is short but very informative. Thank you.

  • @ricardofogel671
    @ricardofogel671 หลายเดือนก่อน +1

    Fantastic explanation, thanks for teaching me additional symptoms this code produces.

  • @christianlorenz843
    @christianlorenz843 ปีที่แล้ว +1

    Thanks!

    • @Top5AutoRepairs
      @Top5AutoRepairs  ปีที่แล้ว +1

      Thank you for supporting the channel!

    • @christianlorenz843
      @christianlorenz843 ปีที่แล้ว

      @@Top5AutoRepairs
      You bet! Thanks for the help. 🤙

  • @johnvrbka570
    @johnvrbka570 ปีที่แล้ว +6

    As a mechanic I just replaced one on a 17 duramax LP7 it's located on the front rh side rail. Just remove the inlet air tube & throttle valve. There was a discrepancy between sensor 1 & 2 took me a while to figure out there is only one sensor meaning there are 2 sensors in one. Test states key one engine off & should be no more than like 290 psi difference between the 2. It was well with in the spec. While driving I could see 3000 psi difference between the 2. There is also a bulletin about the connector. It looked good and did a drag test & felt good but I replaced the connector anyway. After which I saw around 100 psi difference between the 2. Problem solved. Oh was getting a po191

  • @shwndh
    @shwndh ปีที่แล้ว +2

    Awesome man! Short and straight to the point.
    I'm having P0089. I'm thinking my issue is the the low pressor fuel sensor or low pressure pump. No drivability issues. Listing the P0190 codes is helping me to eliminate the high pressure fuel rail sensors.

    • @ricardorohden5421
      @ricardorohden5421 3 หลายเดือนก่อน

      Have you fixed it? im having a intermitent P0089. Thank you

    • @shwndh
      @shwndh 3 หลายเดือนก่อน

      @@ricardorohden5421
      Yes. ECM update with GAP IID tool fixed the issue. It was just an over sensitive algorithm.

    • @ricardorohden5421
      @ricardorohden5421 3 หลายเดือนก่อน

      @@shwndh Did it some months ago, no luck =/
      thank you!

  • @TW-80
    @TW-80 ปีที่แล้ว +4

    Had a problem for months, symptoms started as a slight, random and intermittent "cough" at motorway speeds. No engine light or fault codes, then it got a bit worse after a while with a random dive under hard acceleration. then I finally got the p0193. It really took about 6 months if driving to finally get a code. Ford Mondeo 2008, 2.5T

    • @JS-ri2rx
      @JS-ri2rx ปีที่แล้ว

      What was the problem?

    • @ScienceDayYT
      @ScienceDayYT 7 หลายเดือนก่อน

      What was the problem?

    • @chaps203
      @chaps203 5 หลายเดือนก่อน

      Same situation on my 04 Lincoln LS v8. Hoping replacing the sensor will do the trick cause hoses and all that seem out my wheelhouse

    • @DigitalDissident
      @DigitalDissident 4 หลายเดือนก่อน

      What was the problem?

  • @jtdouglas9535
    @jtdouglas9535 10 หลายเดือนก่อน +1

    Great stuff my friend great stuff

  • @htiekmahned8859
    @htiekmahned8859 หลายเดือนก่อน

    My 2.5T volvo stumbles and misfires. Have to press gas pedal to crank and run. Sometimes unhook battery to reset it when gas pedal unresponsive. It cuts out on sharp turns very briefly. Lots of hiccups and feel slight power surges going uphill. Have p0193 code.

  • @stephenfritz7493
    @stephenfritz7493 ปีที่แล้ว +4

    ...fixed a hard start for me

  • @mohammedsajjad5943
    @mohammedsajjad5943 ปีที่แล้ว +2

    Will there be a possibility of code not appearing but pressure sensor is bad.

  • @michaelminichini6651
    @michaelminichini6651 23 วันที่ผ่านมา

    This is most likely my problem in 2017 Mazda 3. I am about 40 miles from home. Noticed poor gas mileage on ride here. Will i be doing harm to my engine driving the car 40 miles home?

  • @danieljavier7104
    @danieljavier7104 6 หลายเดือนก่อน

    Having a P0191 on a 2008 mustang have replaced the sensor once already any ideas ?

  • @joenguyen-vlog8063
    @joenguyen-vlog8063 ปีที่แล้ว +1

    So the possible cause could be the fuel pump ?
    I am getting a code P0192 for 2016 CX5. Already replaced the fuel filter and the pressure sensor.
    Car can start and idle. But do have that code.
    Any suggestions?

    • @JackedITguy
      @JackedITguy ปีที่แล้ว

      did u change the fuel pump and it got rid of light?

    • @joenguyen-vlog8063
      @joenguyen-vlog8063 ปีที่แล้ว

      @@JackedITguy
      Code is there after the pump was replaced.

    • @JackedITguy
      @JackedITguy ปีที่แล้ว

      @@joenguyen-vlog8063 yeah I think might have to replace the fuel pump in in a similar situation rn will do it when I have the time

  • @josuekisembo1177
    @josuekisembo1177 ปีที่แล้ว +1

    I’m getting P0191 on 1AZ-FSE only after long distance drive. hesitation symptoms , check engine light come and disappear, after restart I can normally drive but just feeling low acceleration, is this pressure pump or I can still replace the fuel rail pressure sensor,

    • @carlosmerino5547
      @carlosmerino5547 ปีที่แล้ว +1

      I will replace fuel rail pressure sensor first, and drive for wall , if not take to mechanic to check fuel pressure , they will tell if fuel pump, check fuel filters if it has if not have fill filter throw in trach that truck. All truck must have fuel filters, start with filter first

    • @yasinugur986
      @yasinugur986 8 หลายเดือนก่อน

      Hi my friend, can you pleade share with me how you solved it? I have the same deviation and couldnt find any solution :(
      Would be very helpfull.

  • @orlandocastillo8232
    @orlandocastillo8232 4 วันที่ผ่านมา

    I have a 2015 F-250 Ford Diesel I
    Having problems
    Engine reduced
    Have a coat
    P0191

  • @뚜벅이오
    @뚜벅이오 10 หลายเดือนก่อน +1

    I got the code 0192 and it cranks, but it doesn't start at all?

    • @smokieklown274
      @smokieklown274 10 หลายเดือนก่อน

      Common with Fuel rail system pressure too low ( also a P0087 code) im having the same issues.. obly its throwing both P0087 and P0088..

    • @smokieklown274
      @smokieklown274 10 หลายเดือนก่อน

      *only

  • @fullycircle262
    @fullycircle262 3 หลายเดือนก่อน

    that sensor can give error code like "fuel temp issue" ?

  • @saifo7773
    @saifo7773 ปีที่แล้ว

    cobe 2539 patrol y62 and I changed the fuel pump front and back and the problem is still there

  • @jansotik8466
    @jansotik8466 ปีที่แล้ว

    Hello , I have Dodge Nitro 2,8 crd , 4x4 177PS , 130kw 2008 . Somebody who knows fault code P2453? Fuel filter pressure sensor ?

  • @ajharkhan88
    @ajharkhan88 ปีที่แล้ว +2

    P08700 fulte code Audi Q5 diesel

  • @escobaresco7855
    @escobaresco7855 ปีที่แล้ว

    can it cause misfire

  • @orlandocastillo8232
    @orlandocastillo8232 4 วันที่ผ่านมา

    I'm getting a p0191
    Change it
    Still comes out with a coat

  • @MarieGamboa-w2e
    @MarieGamboa-w2e ปีที่แล้ว

    Fuel short circuit problem

  • @bolden2k12
    @bolden2k12 ปีที่แล้ว +1

    Im getting a P.0087 code

  • @dxcpasamonte8347
    @dxcpasamonte8347 ปีที่แล้ว

    I changed the sensor, but still up and down pressure

    • @konstantin-big
      @konstantin-big 7 หลายเดือนก่อน

      Then the problem wasn't a bad fuel rail pressure sensor
      Did find a solution????

  • @mystiktv4066
    @mystiktv4066 10 หลายเดือนก่อน

    I’m getting P016F

    • @jacobchitwood4365
      @jacobchitwood4365 4 หลายเดือนก่อน

      Same. Did you figure anything out??

  • @DigitalDissident
    @DigitalDissident 4 หลายเดือนก่อน

    +1

  • @TechGod7
    @TechGod7 6 หลายเดือนก่อน

    Mine is leaking could I replace it?