Hi. Sorry to hear about your problem. I hope you have already found a solution. Mine started doing it today after a crash. Please help if you have found any solution. Thank you
I have the exact same problem plus what Banggood had sent had a twisted boom which put the tail motor at an odd angle. I've messed with my controller settings a ton and still can't figure out what's wrong. Current status is trying to get a refund or a replace from Banggood.
A 6G calibration flight should fix this.
What are those blades off of? They are green and not the original could you tell me what they are off of?
I found the solution. It is from the bent feathering shaft. I fixed it and the problem has been solved thanx to advice from @microrcfriend
Nice, thanks. I'll give that a try when it starts warming up here
Hi. Sorry to hear about your problem. I hope you have already found a solution. Mine started doing it today after a crash. Please help if you have found any solution. Thank you
X9d plus you using module multiprotocol??
I have the exact same problem plus what Banggood had sent had a twisted boom which put the tail motor at an odd angle. I've messed with my controller settings a ton and still can't figure out what's wrong. Current status is trying to get a refund or a replace from Banggood.
Did you ever find out an answer for this? Mine does the same but on the left servo.
I suspect it's the main board. Got a partial refund from banggood and ordered another xk110. I have not tried it out yet though.
Odd that it's on the left servo though, maybe a servo issue?
David Mitchell my Xk k123 is doing the same on the left servo and I have had it for 2 months and it just started doing it
Try to remove the connector then return it back..may it help
In 6g mode. Threshold must be not exceed 70%.
It work 100%