Hi, first of all thanks for the video and how well you explained it. I have a little problem, I followed all your steps and for some reason after finishing the repair I get the "Face ID is not available. Try again later". I've tried every solution I've found in the internet: cleaning camera, trudepth and dot sensors, reseting face id, reseting the iPhone, updating it, even reinstalling the firmware, but nothing works. However, it is a little bit strange because after reseting or reinstalling the firmware, the first time when I'm setting the face id everything works and after that if I try to use it, it doesn't work, and if i reset it and try to set it again it doesn't work. I don't know what may be happening but I would aprreciate very much your help or any other's. Thanks in advance
Most likely the dot projector and the infrared camera aren’t looking at the exact same location. They have to be precisely looking at the same spot. It might have projected enough dots on your face to set it up, but it can’t map it out properly after that. Check the alignment and secure them better to the frame.
Definitely one way to do it for sure. I just like to have a fully intact frame instead of cutting out the back part of the frame and rigging it to look somewhat decent after. Great comment !
New subscriber.. that is so cool and relaxing to watch
Thanks for subbing!
Just wondering I don’t have a tack welder or super glue, is it too risky if I don’t use either
Could we possibly have the link to get the casing for the camera
You can find it at mobilesentrix.com
What is the substitute for welding? Can i just glue it or anything without performing a weld? Thank you!
Welding is definitely better, but glueing is possible you just need to be careful
Hi, first of all thanks for the video and how well you explained it.
I have a little problem, I followed all your steps and for some reason after finishing the repair I get the "Face ID is not available. Try again later".
I've tried every solution I've found in the internet: cleaning camera, trudepth and dot sensors, reseting face id, reseting the iPhone, updating it, even reinstalling the firmware, but nothing works.
However, it is a little bit strange because after reseting or reinstalling the firmware, the first time when I'm setting the face id everything works and after that if I try to use it, it doesn't work, and if i reset it and try to set it again it doesn't work.
I don't know what may be happening but I would aprreciate very much your help or any other's.
Thanks in advance
Most likely the dot projector and the infrared camera aren’t looking at the exact same location. They have to be precisely looking at the same spot. It might have projected enough dots on your face to set it up, but it can’t map it out properly after that. Check the alignment and secure them better to the frame.
@@FIXDPHONES Thanks a lot for the advice! I'll try that
Where can we get the super glue for iPhone?
Awesome video bro
Appreciate it
great job 👏
Thank you! 😃
👍
Great
It’s better change front camera in same module without damging face id
Definitely one way to do it for sure. I just like to have a fully intact frame instead of cutting out the back part of the frame and rigging it to look somewhat decent after. Great comment !
You from