2016 Mustang Gt stock . Motor craft plugs Iridium Check only with feeler gauge . .049 Do Not gap them . Anti Seize very lightly . The coil packs , lift red clip while lightly pushing in in middle of plug at the red part of clip . Then push in black area of plug easy to see . You can push wire harness up a little to make room for clip to push off . Electrical grease lightly coil pack top and where plug fits in . Tighten plugs and coil packs bolts lightly 7 pds . It's an easy job You can Do It Go Slow . Number 4 by battery box will come out without moving battery area . Use 3 inch ext, two of them .
Don't listen to this guy, actually if you put antiseize on plugs with coatings you could strip/break them off in the cylinder, plus impedes the grounding of the plug to the aluminum cylinder heads.
Shop these Ford Performance Spark Plugs! : muscle.am/3oeyj8o
2016 Mustang Gt stock . Motor craft plugs Iridium
Check only with feeler gauge . .049 Do Not gap them .
Anti Seize very lightly .
The coil packs , lift red clip while lightly pushing in in middle of plug at the red part of clip . Then push in black area of plug easy to see . You can push wire harness up a little to make room for clip to push off . Electrical grease lightly coil pack top and where plug fits in .
Tighten plugs and coil packs bolts lightly 7 pds .
It's an easy job You can Do It Go Slow . Number 4 by battery box will come out without moving battery area . Use 3 inch ext, two of them .
Could you do an install video like this for the FP GT500 aluminum valve covers?🤓
So what happens if i use this on my stock coyote ?
Why disassemble everything and leave the risk that there will be debris and dust that can enter the engine is not very advisable
What? How else are you going to get to the spark plugs without disassembling everything? There’s always dust somewhere no matter what.
Preignition and detonation are not the same thing.
Miss and bought these but didn’t know it was for booster stangs. Glad I didn’t put em in 😭
might want to pull these and use the proper heat range and gap (.049) for a naturally aspirated car folks
Skip to 19:01, Up until 19:01 you just see a hand turning a ratchet😐
You must put antiseze on all 8 spark plugs or you take a risk to stripping the tread......
You don’t have to put that on these plugs. It strictly says NOT to on the instructions when you get them.
Don't listen to this guy, actually if you put antiseize on plugs with coatings you could strip/break them off in the cylinder, plus impedes the grounding of the plug to the aluminum cylinder heads.
Music ruins the main thing wich is hearing him , next time please less music everything else very helpful .