Installing An EGT Sensor on a Smarty Touch

[@ladindustries2429]

Thank you so much mate, all I wanted to know was how the compression thing worked and you've made my day. I had been searching for hrs. Bloody legend! Cheers from Australia

[@rodrigofabregas7756]

Thank you for your very useful video!. I have a 2013 RAM 2500 SLT 6.7 (4th gen), already have the smarty touch installed to my OBD 2 connector about 5 years ago (no extra modeule), also bought the EGT probe but did'nt installed it yet. Any big difference in the install with that 3rd gen ?

[@thoroughbreddiesel]

No, pretty much the same. Still want to get the port in the middle of the manifold.

[@bobhupe7084]

Do you know the pin out on the 4 pin connector going to the smarty? Which one is minus thermocouple and which is plus thermocouple?

[@stevelassiter3474]

What are the best things to monitor on mm3 ? I just installed one, good video by the way! I’m getting ready to install the same egt sensor.

[@unclassifiedjz6885]

How much of the probe need to be exposed to give proper readings? Mine only stucks in 1inch out of the 2 inches because it hits my collector? Should i be fine

[@thoroughbreddiesel]

Yes, as long as the probe isn’t bottomed out touching the manifold you should be fine.

[@jeremygless4913]

I have a smarty touch like this video and my sensor stopped working. It just has a blue hour glass. How can I test the sensor? Or do I have to buy another one?

[@thoroughbreddiesel]

Depending on its age, it could be under warranty. If you reach out to smartyresource.com they can help you with a possible warranty.

[@howardtoob]

If I already have a thermocouple in my exhaust can I just purchase the sensor module?

[@thoroughbreddiesel]

Chances are the one you currently have isn’t compatible with the Smarty.

[@markgover3088]

I'm running the same setup. Now for some reason my egt temp is stuck on 3700 degrees.

[@eric2895]

Everything hooked up properly and the egt doesn’t show up on the smarty

[@Gearhead406]

Did you figure this out