Thanks for the vid.
Just changed an H4 headlight bulb on third attempt. As usual once you have done one, the next time will be easy. The main problem is removing the black socket from the rear of the light bulb before you remove the rubber gasket. The manual implies you should squeeze and pull backwards. I was assuming there were some tabs which need depressing to get it to release. There are not. It really is just a case of pulling it back firmly and the bulbs tabs just slot in/out. I found mine were really solid - three people all tried in vain. I had a closer look at the socket on line and once I realised there were no tabs to depress and no wiring to damage on the sides I used a plumbers wrench to grab the socket rear - couple of wiggles and back-pull and off it popped. Easy peasey - Why has no one mentioned this before? Please tell everyone - shout it from the mountains - no copyright.
Yes I am enjoying my cup of tea and biscuit victory moment.
Thank you for the high quality close up photos! I had a problem with beam not being formed correctly and thanks to you I realized my bulb dropped low when I was putting on the bracket! Corrected it and now it's as it should be 🎉
Thank you - I followed your instructions and replaced headlight bulb. It took a lot of wriggling to remove the connector but got there in the end.
Excellent video, I just changed my wife’s ones, i installed led ones and they are brilliant 😊❤
good..job, I m watching ur vedios regularly.. I have Yaris Toyota 2002,,for last few weeks .it's clock setting is out..kindly make a vedio on it.
Hello! Anyone know K12 headlight wiring Diagram Common side is Positive or Negative ?
Большое спасибо, мы до того как посмотрели ваше видео чуть пальцы все не сломали, маялись 2 часа и это не преувеличение
Greetings very well explained I would like you to also explain how to fix toyota yaris 2007 I have one
Btw I just wanted to ask whether K12 has just one bulb that's used as high beam and low beam??
Thhankyou forthe ideal demonstration, with fotos, in other clips the demonstrater works with hands in the motor, you don‘t really see the actual process. the fotos dhow the site and the process ideally
Sorry we necessarily need to disconnect the battery negative side??
i had three different cars and never disconnected the battery while changing bulb
@@KathyelynPraise be to the Lord Jesus Christ that you are still alive to tell your story!
The dip headlight and the first set (morning or meeting light ) is the same h4?
Really useful video thank you, managed to change the lights!
One question, I've also changed the side light bulbs but they don't seem to be working, also checked the fuses and they seem fine. What do you think the problem could be?
I think led bulbs only work in one direction. Did you try taking out the bulbs, turning them 180 degrees and refitting them ?
Can also take out the 2 bolts holding the unit .Whole unit lifts up for better access
Unfortunately there's a third bolt holding the front outer edge of the unit, behind the bumper. You can see it here: th-cam.com/video/0nTN6sz8R1U/w-d-xo.html
@@screwsnutsandbolts
Yes there is ....But removing the 2 bolts means u can lift it up enough to get more access...
Honest guv....lol...
Just be careful not to put too much stress on the remaining bolt bracket or it could snap
E lo stesso procedimento dall'altro faro???
You can leave it connected but make sure the lights are switched off :)
Is too hard :(
Dziękujemy.
Thank you very much for your support !. I really appreciate it 👍👍