nice job, ty for posting, just working on my ‘74 unit and always have trouble with clutch alignment with my old farmer tools. just about to order double cardan rear driveshaft. had too much trouble with my last ‘72 cj moving the perches to get some kind of even ratio alignment even with a small lift.
I have a 90 yj with a 360 AMC engine, and it is running a 4.0 starter .I have a vibration that does not go away with clutch pushed in. Any idea on this would be appreciated.
I assume the vibration is when the vehicle is not moving? What transmission? Does the clutch operate properly and smoothly? My first thought would be an issue with the flywheel or clutch assembly. AMC V-8 flywheels are specific to each motor. Can't run a 304 flywheel on a 360 for example. Will cause a vibration.
You reaffirmed my thoughts, I'm in process of putting a different tran . This 360 is running a 4.0 starter so I know something is wrong. Thank you for your time.
Yes. I think they were ARP bolts I used. I can find the part number/ where I got them and post it. This project was in pieces when I got it. Had none of the original bolts
It's been 25 years since I last did this, very good refresher for me so I don't screw something up, Thanks!
nice job, ty for posting, just working on my ‘74 unit and always have trouble with clutch alignment with my old farmer tools. just about to order double cardan rear driveshaft. had too much trouble with my last ‘72 cj moving the
perches to get some kind of even ratio alignment even with a small lift.
Thanks. For sharing. Very good vid. Great music in background for inspiration. Regards from the Reublic of Panama
Very Nice Job! Getting ready to put mine back together, unfortunately I'll be doing all that on the ground from under neath.
Great video
Looks like to much fun! Btw I love my Milwaukee impact! I have the same one 🤙
Hello , great project man , what motor mount did you use ? I’m swapping my cj5 with a 350
Thanks, it is an AMC 304
Amazing , thank you man for replying you are the best
I am starting the restoration of my grandfathers 79 cj7. Awesome content and info. What trans is this?
Thank you. It is a T176 4spd. Enjoy. That sounds like a great project.
@@millstonejeepworx thanks, I am excited to start.
Did you put a throw out bearing in it
@t.sutt.7768 yes, I have another video showing the removal and installation of it.
I have a 90 yj with a 360 AMC engine, and it is running a 4.0 starter .I have a vibration that does not go away with clutch pushed in. Any idea on this would be appreciated.
I assume the vibration is when the vehicle is not moving? What transmission? Does the clutch operate properly and smoothly? My first thought would be an issue with the flywheel or clutch assembly. AMC V-8 flywheels are specific to each motor. Can't run a 304 flywheel on a 360 for example. Will cause a vibration.
You reaffirmed my thoughts, I'm in process of putting a different tran . This 360 is running a 4.0 starter so I know something is wrong. Thank you for your time.
Did you replace the 1/2-20 flywheel bolts? I cannot find them anywhere.
Yes. I think they were ARP bolts I used. I can find the part number/ where I got them and post it.
This project was in pieces when I got it. Had none of the original bolts
What trans did you go with?
My CJ5 came with a T176 4spd.
Which throw out bearing did you get for it ? Would you happen to have part number ?