How to setup zkteco mb460 access control system
ฝัง
- เผยแพร่เมื่อ 26 ก.ย. 2023
- How to install an access control system using ZKTeco Time and attendance terminal with access control function. This is a practical acess control system Installation training.
The video shows
1. The various components that make an access control system
2. the video introduces the mb460 time and attendance terminal, the access control power supply unit, the Electromagnetic lock and the exit button
3. the video shows how to interpret the wiring diagram for the ZKTeco access control system wiring.
4. how the MB460 Terminal is wired
5. how the mb460 is connected to the power supply unit
6. how the exit button and the magnetic locks are connected to the mb460 time and attendance terminal.
7. how to verify persons through the mb460 using the finger print.
8. access verification through the RFID Card. - วิทยาศาสตร์และเทคโนโลยี
very educative video
Thank you
Very well explained, brother. Thank ( Thailand )
Thank you, Hello to all my friends from Thailand.
thank you . its very supportive info.
You are most welcome
Thank you Sir
Most welcome
Great thanks❤❤❤
You are welcome
Thanx for yo informative lecture. Should we expect for a biometric system setup soon?
Yes, expect more of this and many others including the bio systems
Do you have video for fire alarm system
Thnk you
Most welcome
Why was the com port on mb460 goes into GND port of powersupply and not the com port? Any idea.
I may have to do a deeper study of the circuitry on the power supply to be able to tell you why, but I must say that the circuit has been added to the product by the manufacturer of which I followed the manufacturer's wiring instructions as shown on the circuit diagram.
How did you program the fingerprint to the system and the card as well please
When you go into the system, it gives you the chance to place your finger for number of times and then confirm a successful entry after a number of placements. Same does for the card.
how can i connect biometric to the power supper only to turn it on? is it 12 v and ground only? please advise. thank you!
There is a provided power supply for that purpose.
my power supply no have COM so what I put where?
1. What brand of Access control are you using?
2. Which power supply are you using on it?
3. There should be a wiring diagram attached to the power supply, what does it suggest of where to connect the COM terminals.
Possible to reset without master key?
Please what would you want to reset?
@@Tech_Inside_Outhow can one wipe off existing data on the device without any software. Can it be achieved by hitting the reset button on the back? Thanks
what about the face recognition
Once you input the face by showing your fave to the camera, it would be able to verify you by your face.