G5 control arm replacement noise in suspension, same as cobalt and HHR

G5 REVIVE E4 noise in front suspension most likely a damaged control arm bushing. Show you what to look for and how to replace the control arm on the G5 it is the same for cobalt and HHR. Looking for a cheaper mode of transportation? Want to buy a fixer upper, what to look for and what to do before you buy it. Found a car for under $1,000 but why is it so cheap? See if we can figure out why it's been sitting and better yet make it go again. Multipart series with a total budget of $2,000 to get this car back to road worthy.
See More videos www.youtube.co...
1969 Trans Am video • E2 69 Trans Am convert...
Questions, comments, or want to say hi?
Contact us at [e-mail]
#Pontiac #Revival #G5

[@firstgenerationgarage2803]

This car only reminds me of my Toyota I got the car very cheap and thanks God I am mechanically inclined I was able to make her a beautiful driver on until Bang I got hit so I'm kind of happy that this is the last video on this car cause it's always bringing back memories

[@VinylVillageGarage]

It’s unfortunate to loose a vehicle especially after putting in a lot of work. I hope this car gets us many more years of service. Glad God let you stay to help save them Birds too!

[@firstgenerationgarage2803]

@@VinylVillageGarage So are you going to have time to me in PA

[@DugEphresh]

Outstanding! Thanks for posting, great commentary and attitude.

[@VinylVillageGarage]

Right on glad to help.

[@donteatsoap7]

Very nice, thank you!

[@VinylVillageGarage]

Very welcome

[@Chaotic_Focus]

My 2010 Cobalt is making a little knocking/ bumping noise when I drive slowly over rough areas. I'm hoping that's what I need.

[@VinylVillageGarage]

Very well
Could be, quick visual inspection will tell you.

[@Chaotic_Focus]

I didn't see anything that stood out to me when I was underneath changing oil last time. I bounced the car up and down but of course it was on raps instead of the wheels off the ground.

[@jaycenandrews7537]

Can you replace just the bushing? Instead of the entire control arm?

[@VinylVillageGarage]

Yes a new bushing could be pressed in, you might find the price of the bushing and time to press it in VS replacing the entire control arm may not be worth the effort.

[@kyranblake3337]

How to tell if the control arm is aluminum or stamp metal ?

[@VinylVillageGarage]

Quick way will a magnet stick to it? Magnet sticks it’s steel falls off aluminum