Range Rover Evoque Rear Brake pad and Rotor Replacement

This week we learn how to replace the rear brake pads and rotors on a 2012 Range Rover Evoque, as well as put the vehicle into maintenance mode.
Support the cars! -shop.spreadshi...
Subscribe! / 68c20lwb...​
Follow me on Instagram / ​
Follow me on Snapchat @ augshog
More Caprice PPV content here: • We Bought an Ex-Cop Ca...
More C20 content here: • Moving My 1968 Chevy C...
1965 Impala SS content: • Eighth Mile Drag Racin...
LS swapped Nissan 240sx content: • We Bought A New Projec...
Turbo Joyner rev limiter action: • I Bought A $3,500 RZR ...
Trailblazer SS thrashing: • Launching My AWD Trail...
Message me at [e-mail]
#mickelsonracingchannel #crapiece #sickweek
Check out these other great channels!
@Mortske Repair
@Puddin's Fab Shop
@C&C Auto Works
@JAWS at B&C Performance
@Stapleton42
Music from www.bensound.com

[@13salinaspride]

I got the exact same rover. My girls suv and the all the rotors/ brakes shot. Thanks for the video helped me out:)

[@MickelsonRacingChannel]

Awesome, I’m glad I could help!

[@WoodLox]

For those stubborn bolts I use the impact manual tool. Knock it a few times to break off the crud on the threads. Someone mentioned using a punch, definitely your girls dad would if he was in the situation. That’s how my dad taught me, nothing like farm hands. Heat or just weld a T56 to it, usually so tight it breaks the bits or strips. Got her done, all that matters.

[@MickelsonRacingChannel]

Sounds like the punch was the way to go for this deal

[@VetTrax]

6:16 use a pointed punch and hammer to remove stubborn torque screws. Punch a deep enough mark between the rotor and the screw head.
Turn the punch on a slight angle and hit it with the hammer. It’ll eventually move. 👌🏾

[@MickelsonRacingChannel]

Nice trick!

[@MortskeRepair]

That thing must have a good radio

[@MickelsonRacingChannel]

Better than mine!

[@Herpsnhotrods]

There's a trick to getting those stubborn rotor bolts out. Take a punch and make a dent in the bolt head and use the punch in the dent and hammer the punch counterclockwise. I had to do I for a friend with a Honda that had a stripped head on the rotor bolt.

[@MickelsonRacingChannel]

That’s a pretty good tip!

[@OFFICIALRover]

How reliable has this car been? Great video man thinking about getting a 2020

[@danjackson5072]

Mine won’t get out of maintenance mode!

[@MickelsonRacingChannel]

Did you go through the procedure again with a fully charged battery?

[@danjackson5072]

@@MickelsonRacingChannel Ended up disconnecting the battery and then it worked