Roof Rack Zombie Lights for $100!

Want zombie lights on your roof rack? We can do it for about $100!
The lights I used:
SIDE LIGHTS (x4): www.amazon.com/gp/product/B07...
REAR LIGHTS (x2): www.amazon.com/gp/product/B08...
***********************
Make sure to follow and subscribe to this channel and follow our photos on Instagram: baptismoverland

[@alonewolf858]

👍🏿👍🏿two thumbs up from Australia 🇦🇺 I took your advice and tips saved me a bucket loads of time

[@roneckler6235]

Thanks. I bought the rear 2 and the items (on the bottom of that page) that are recommended with it (harness and mounts) for a great total price!

[@tahltan1910]

Good info, thank you 👍🏼

[@jeremyloya9074]

Great video!

[@elementalblaze79]

Great video 1st off but I would have done only one thing different then what you did here & it would be with the wiring, I would have wired the lights to one side vs down the center, sure it would have only saved roughly 4 feet of wire(roughly 2 feet of each of the positive & negative wires) but it would be easier imo to work on if I have/need to work on the wire loom! Plus, I'm using 80/20 Inc's 10 series extruded aluminum(yes, it's costly & time consuming, ie cad is a pain for me but I need a modular setup for my rig & none of the racks out there fit the bill) for my roof rack so I know I can easily hide my wires to make it a clean install! Again, nice video!

[@BaptismOverland]

I agree. This was when I first got the roof rack. I have a totally different rack & setup now and all the wiring has completely been overhauled. :)

[@BaptismOverland]

In fact in my new setup with the front runner rack, wires are now going through the hardtop using a cable gland (video on that as well) and my zombie lights are now exposed in a way where I can disconnect them fr the wires when needed. I also have a chase light installed for the rears as well. I learned a ton after this video about them not being accessible- lessons you just brought up, I learned the hard way 😂

[@Brit_explorer]

Have you tried using marine heat shrink instead of electric tape?

[@BaptismOverland]

Every electrical I've done SINCE this video has been nothing but marine grade heat shrink lol

[@Kid617]

What size gauge wire used for the harness

[@BaptismOverland]

Due to length I'm using 12. There's a chart you can use depending how long your wire is going to be so you don't get voltage drop.

[@seadoo_detroit]

Whats the switch panel from

[@BaptismOverland]

Apollointech switch pod

[@htownsfinest87]

So not video in the dark

[@BaptismOverland]

Unless you have a camera that is good in low light which I actually have now 😉