Looks good! Laying here watching and i dropped my tablet on my nose-- after getting tissue for my bloody nose. Does the silver brass load as well as the brass?
I did one load with the steel pins and put them on a shelf and left them there. They were more of a pain to get out of the brass when they were wet than it was worth. The tumbler cleans brass well enough without them.
I would argue with you that I used too much of everything in that video. I had the drum pretty much loaded to maximum capacity with cases also. Thanks for watching 👍
Really ! You over fill it to the point that AII the pins got stuck on one side of the tumbler ? WHY? Non of your brass tumbled it just went in nice circles for 3 hours. I dont get the point, obviously you have a lot of experiance this just seemed counter productive.
Well for starters..., you're right. I did overfill the tub in this video. Did it work? Yeah. Would it have worked better less full? Perhaps. Would it have worked faster less full? Probably. Concerning the pins; while several of them stayed in the end, several more found their way into the mixer. I'm still pulling the occasional pin out of the brass. For the most part I've discovered that adding the pins to the mix provides minimal gain to the cleaning process and I usually omit them. That said, for the video I overloaded the drum to see if it would work that way, because it's something that is likely to happen in the wild. My thought process was that someone was going to buy one of these things, overload it, then complain that it didn't work. I wanted to see if it would work that way and it did. I didn't explain that very well in the video. Thanks for watching 👍
Looks good! Laying here watching and i dropped my tablet on my nose-- after getting tissue for my bloody nose. Does the silver brass load as well as the brass?
Ouch!
I did one load with the steel pins and put them on a shelf and left them there. They were more of a pain to get out of the brass when they were wet than it was worth. The tumbler cleans brass well enough without them.
I agree with your assessment.
Looks like the tumbler works well 👍.
It worked real good, and I'm glad. I had high hopes for it.
Can you use the tumbler for coins can you let me know thanks Gareth 👍
I don't see why not. I've use them to clean small parts and stuff before also.
Hope that helps.
Thanks for watching!
I finally ordered one! 🙄
I've been real happy with it.
I think you’re using way too much of the steel pins. I use a quarter of that and it comes out nice.
I would argue with you that I used too much of everything in that video.
I had the drum pretty much loaded to maximum capacity with cases also.
Thanks for watching 👍
Really ! You over fill it to the point that AII the pins got stuck on one side of the tumbler ? WHY? Non of your brass tumbled it just went in nice circles for 3 hours. I dont get the point, obviously you have a lot of experiance this just seemed counter productive.
Well for starters..., you're right. I did overfill the tub in this video.
Did it work? Yeah.
Would it have worked better less full? Perhaps.
Would it have worked faster less full? Probably.
Concerning the pins; while several of them stayed in the end, several more found their way into the mixer. I'm still pulling the occasional pin out of the brass.
For the most part I've discovered that adding the pins to the mix provides minimal gain to the cleaning process and I usually omit them.
That said, for the video I overloaded the drum to see if it would work that way, because it's something that is likely to happen in the wild. My thought process was that someone was going to buy one of these things, overload it, then complain that it didn't work. I wanted to see if it would work that way and it did. I didn't explain that very well in the video.
Thanks for watching 👍